Argo N13436 Panduan Servis - Halaman 16

Jelajahi secara online atau unduh pdf Panduan Servis untuk Kendaraan Offroad Argo N13436. Argo N13436 16 halaman. Ducting & exhaust

Argo Service Manual

Fasten the duct at the upper hood brace assembly

Perform the servicing procedure, Installing the Muffler (Response, Vanguard2

and Vanguard Models) or: Installing the Muffler (Bigfoot Models)

Reinstall the bumper.

Removing the Exhaust Ducting (Conquest from C19686, all 6x6 Conquests and all

35th anniversary vehicles)

Perform the servicing procedure, Removing the Muffler (Conquest) on page DE-7

of this service guide.

Remove the 2 fasteners securing the exhaust ducting to the hood support brace. See

Photo DE-32 previous page.

The exhaust ducting is secured at the other end by a body rivet located at the upper

body beneath the rubber bumper. See Photo DE-33 previous page Peel back the

bumper and drill out both rivets.

Pull the duct assembly in towards the engine compartment and up and out of the

vehicle.

Installing the Exhaust Ducting (Conquest from C19686, all 6x6 Conquests and all

35th anniversary vehicles)

Insert the ducting into the engine compartment. Slip the exhaust duct support be-

tween the upper and lower body aligning the holes in the support, with the rivet

holes of the previously removed rivets.

Insert 2 body rivets through the body and shroud support, and secure with 2 washers

below.

Fasten the duct at the upper hood brace assembly

Perform the servicing procedure, Installing the Muffler (Conquest) on page DE-8

of this service guide.

Reinstall the bumper.

Ontario Drive & Gear Limited

PH.(519)- 662-2840 FAX (519)- 662-2421

Ducting & Exhaust

DE-15