Cisco ASR 9910 Manual - Halaman 29
Jelajahi secara online atau unduh pdf Manual untuk Perangkat Keras Jaringan Cisco ASR 9910. Cisco ASR 9910 44 halaman. Replacing cisco asr 9000 series router components
Halaman Cetak- 1. Field Replaceable Units
- 2. Online Insertion and Removal
- 3. Powering off the Router
- 4. Replacing the Chassis Air Filter
- 5. Required Tools and Equipment
- 6. Removing a Fan Tray
- 7. Installing a Fan Tray
- 8. Disconnecting AC Power
- 9. Reconnecting AC Power
- 10. Disconnecting DC Power
- 11. Reconnecting DC Power
Replacing Cisco ASR 9000 Series Router Components
rommon B1> RSP_LINK_1G=1
rommon B1> sync
Step 5
Verify that config register is set correctly in ROMMON:
Example:
rommon B1> confreg
Step 6
Reset RP2 card in ROMMON. Now the RP2 becomes the standby RP in slot 0 and synchronizes configuration
from active RSP440 in slot 1.
Example:
rommon B1> reset –h
Note
Step 7
Wait until standby node reach NSR-ready state and status of ALL the groups is Ready state. Use show
redundancy command to verify the same.
Step 8
From active RP, verify the both RPs have synchronized the SNMP engine ID and SNMP ifindex-table between
each other:
Example:
#more disk0:snmp/ifindex-table loc 0/rp0/cpu0
#more disk0:snmp/ifindex-table loc 0/rp1/cpu0
#more disk0:snmp/snmp_persist loc 0/rp0/cpu0
#more disk0:snmp/snmp_persist loc 0/rp1/cpu0
Step 9
Manually copy Embedded Event Manager (EEM) scripts from RP1 to RP2 disks if applicable.
Note
Step 10
Perform redundancy switchover from active RP1 to standby RP2.
Example:
Router# redundancy switchover
Note
Step 11
Verify that the active RP is RP2 and it has the running configuration from RP1.
Example:
Router# show redundancy summary
Router# show running config
Step 12
Remove RP1. Follow the procedure explained in the topic
on page
The RP2 card reloads and user is disconnected from ROMMON automatically.
The EEM scripts are files located on RP's hard disk. These files are not automatically synced
between Active and Standby RPs.
A physical OIR is not supported, hence you must perform CLI switchover.
25.
Removing and Replacing Cards from the Chassis,
Replacing Cisco ASR 9000 Series Router Components
Migrating from RP1 to RP2 Card
29