Cisco ATA 191 Panduan Administrasi

Jelajahi secara online atau unduh pdf Panduan Administrasi untuk Perangkat Keras Jaringan Cisco ATA 191. Cisco ATA 191 4 halaman. Analog telephone adapter
Juga untuk Cisco ATA 191: Panduan Pengguna (30 halaman), Panduan Pengguna (10 halaman), Memulai (8 halaman), Manual (10 halaman), Panduan Memulai Cepat (13 halaman), Setup Manual (6 halaman), Panduan Pengguna (40 halaman), Panduan Pengguna (30 halaman)

Install the ATA 191

•

ATA 191 Installation Information

You connect the ATA 191 hardware and configure the ATA 191 by loading the QED and firmware files.

Install the QED file first, then install the firmware file. For more information about loading the QED and

firmware files, see the "Installation Notes" section of the "Release Notes for Cisco ATA 191 Analog Telephone

Adapter".

Network Requirements

The ATA 191 acts as an endpoint on an IP telephony network. The following equipment is required:

• Call Control system

• Voice packet gateway—Required if you are connecting to the Public Switched Telephone Network

• Ethernet connection

ATA 191 Installation Information, page 1

Network Requirements, page 1

Safety Recommendations, page 2

Package Contents, page 2

Install Your Cisco ATA , page 2

Attach a Phone to the ATA 191, page 3

Startup Process Verification, page 3

Configure Startup Network Settings, page 4

Security on the ATA 191, page 4

(PSTN). A gateway is not required if an analog key system is in effect.

Cisco ATA 191 Analog Telephone Adapter Administration Guide for Cisco Unified Communications Manager