Argo SN7841 Panduan Servis - Halaman 14

Jelajahi secara online atau unduh pdf Panduan Servis untuk Kendaraan Offroad Argo SN7841. Argo SN7841 16 halaman. Ducting & exhaust

Argo Service Manual

Installing the Intake Duct (Response, Bigfoot, Vanguard2 & Vanguard Models)

Install the intake duct inserting it closest to the front of the vehicle. This is where the

widest available area allows it to be pushed into the vehicle. Position it in front of the

engine flywheel fan assembly.

Fasten the intake duct to the hood support assembly using the spacers and 2 fasten-

ers.

On 6x6 Vanguards manufactured prior to S8131, reconnect the extension spring from the

intake duct to the molly hook on the lower body.

Secure the fuel line to the nylon clips at the intake duct.

Conquest models maufactured prior to CB17117 utilize a sheet metal style intake duct.

Intake ducts on Models manufactured from the above serial number, are made of moulded

plastic.

Earlier sheet metal ducts are no longer available, but the newer style is fully

exchangeable. However, optional parts are necessary when ordering your replacement.

To remove the intake duct on Conquest models, the upper body must be split from the

lower body.

Peel off the rubber bumper assembly

from the vehicle. You need only strip it

off far enough off to drill out the speci-

fied rivets.

Using a 3/16" drill bit, remove the riv-

ets starting from the front center of the

vehicle to approximately the dash area.

Photo DE-31

Separate the upper and lower body, sup-

porting it apart using a couple of 2x4 pieces of wood.

Locate the fasteners securing the intake duct to the lower body and remove.

Raise the upper body from the lower high enough to accommodate the height of the

duct as you pull it out from between the two.

Ontario Drive & Gear Limited

PH.(519)- 662-2840 FAX (519)- 662-2421

Ducting & Exhaust

DE-13

DE-31