DIGITIZE System 3505 Panduan Instalasi dan Pengoperasian - Halaman 12

Jelajahi secara online atau unduh pdf Panduan Instalasi dan Pengoperasian untuk Alat Ukur DIGITIZE System 3505. DIGITIZE System 3505 20 halaman. Remote alarm terminal option
Juga untuk DIGITIZE System 3505: Panduan Pengoperasian (12 halaman)

Halaman Cetak

Once the password is entered, and the SET key is pressed, you will see the BT selection

menu. Enter the desired BT-2 number (BT #2 is shown above). If the BT exists, then

the BT-2 Status will either be displayed as ACTIVE or DISABLED. To disable a BT-2

(presumably for a long period of time) move the cursor by pressing the FUNC key until it

is under the word ACTIVE. Simply press the ON or OFF key on the SYSTEM 3505 to

change the status to DISABLED. No information is sent to the Monaco box. The

disabling process of the BT-2 does not apply for activation of a BT-2, or for adding a new

BT-2. In the case of adding a new BT-2 the BT-2 status will be noted as NONE.

To ADD or CHANGE the configuration of a BT-2 unit you must first enter the desired

BT-2 number into the 3 6 SET menu. Move the cursor by pressing the FUNC key and

enable of disable the desired zones by using the ON/OFF keys when the cursor is at the

location of the desired zone. A display of the actual zone number indicates that the zone

will be active when you activate the desired BT-2. An X or XX indicates that the

selected zone will be disabled, when you activate the desired zone. Once you make all

the selections, press the "Activate selection now" soft key. If the selected BT is on line,

the printer the following information:

If the BT-2 is not on line, then only the request will be printed.

DIGITIZE, INC. 700270 REV A 01/06

1-7

Specifications Subject to Change Without Notice