Cisco Catalyst 2960-XR Panduan Pemasangan Perangkat Keras - Halaman 34
Jelajahi secara online atau unduh pdf Panduan Pemasangan Perangkat Keras untuk Perangkat Keras Jaringan Cisco Catalyst 2960-XR. Cisco Catalyst 2960-XR 34 halaman.
Juga untuk Cisco Catalyst 2960-XR: Panduan Memulai (25 halaman), Manual Perangkat Keras (20 halaman)
Halaman Cetak
Where to Go Next
Device
Switch to computer or server
Switch to router
Switch to IP phone
1 100BASE-TX and 1000BASE-T traffic requires twisted four-pair, Category 5 or higher. 10BASE-T traffic can use Category 3 cable or higher.
Where to Go Next
If the default configuration is satisfactory, the switch does not need further configuration. You can use any
of these management options to change the default configuration:
• Start the Network Assistant application, which is described in the getting started guide. Through this
• Use the CLI to configure the switch as a member of a cluster or as an individual switch from the console.
• Use the Cisco Prime Infrastructure application.
Catalyst 2960-X and 2960-XR Switch Hardware Installation Guide
34
Crossover Cable
No
No
No
GUI, you can configure and monitor a switch cluster or an individual switch.
1
Straight-Through Cable
Yes
Yes
Yes
Switch Installation
OL-28309-02