Argom Tech A1002 Manual - Halaman 6
Jelajahi secara online atau unduh pdf Manual untuk Ponsel Argom Tech A1002. Argom Tech A1002 16 halaman.
Warning: Do not bend or scratch the SIM card, or contact static, dust or water; if the SIM card is lost,
please contact your network operator. Please switch off the mobile phone before installing the SIM card. The
SIM card is inserted into the rear side of the mobile phone.
Note: The T-flash card is tiny. Please keep it away from children to avoid swallowed. If the SIM card is
invalid or damaged, the phone displays "Insert SIM card". Switch off the phone and take out the SIM card, and
then re-insert it into the slot properly. If the SIM card is damaged, please contact your network operator. If the
SIM card is locked, please contact your network operator.
Battery and charging
Installing the battery
Only use qualified battery and accessories. When the battery isn't used, put it in the protective case.
Note: Please operate according to the figure to avoid damaging the battery contact.
Charging the battery
The new battery will reach its optimized performance after complete charging and discharging for several
times.
Please charge in time when the battery voltage is low. Over discharging will damage the battery.
Disconnect the charger from the AC power supply and the mobile phone after charging. While charging, the
battery status icon flashes from right to left, and stops flashing after charging. It is normal that the battery
becomes warm in the charging process.
Using 2-in-1 charger (charger + data cable)
The 2-in-1 charger may charge the battery through the mobile phone.
1> Connect the data cable and charger
2> Connect the data cable of the 2-in-1 charger to the I/O slot of the mobile phone.
3> Connect the charger plug of the 2-in-1 charger to the appropriate power outlet.
4> During charging, the icon of battery status blinks until the charging completes.
5> After charging, the battery icon stops flashing, and you can pull out the 2-in-1 charger.
Note: If the battery voltage is too low and can't turn on the mobile phone, the charging icon may appear
on the screen after several minutes. The mobile phone may be turned on or off during charging.
Warning: Make sure that the local voltage and power match the rated voltage and power of the 2-in-1
charger.
Switching on/off
1> Press and hold the End key to switch on the mobile phone. The screen shows the power on video.
2> If the phone lock is activated, please input the password and press "OK" key. The default password is
1122.
3> If the PIN code is activated, please input the code and press "OK" key. The PIN code is provided by
the
network operator.
4> Access to standby interface.
5> Press and hold the End key to switch off the mobile phone.
6