Cisco Firepower 4110 Manual - Halaman 3

Jelajahi secara online atau unduh pdf Manual untuk Perangkat Keras Jaringan Cisco Firepower 4110. Cisco Firepower 4110 26 halaman. Rack-mount and ground the chassis
Juga untuk Cisco Firepower 4110: Panduan Pemeliharaan dan Peningkatan (20 halaman), Manual (36 halaman), Manual (8 halaman), Manual (42 halaman), Memulai (42 halaman)

Halaman Cetak

Installation, Maintenance, and Upgrade

This procedure describes how to install a network module into an empty slot that has never contained a network

module, and how to remove an installed network module and replace it with another network module.

Step 1

To install a new network module for the first time into an empty slot, do the following:

a) Power down the chassis by moving the power switch to the OFF position.

See

Rear Panel

b) Follow Steps 4 through 7 to install the new network module.

c) Power on the chassis by moving the power switch to the ON position.

The state for the new network module is

d) To change the status of the network module to

Chassis" topic in the System Administration chapter in the

Step 2

To remove and replace an existing network module, do one of the following:

a) Save your configuration.

b) Power down the chassis by moving the power switch to the OFF position (if removing a network module that does

not support hot swapping).

See

Rear Panel

c) Bring the network module offline using the appropriate CLI command (if removing a network module that supports

hot swapping). All network module configuration is saved. See the "Taking a Network Module Offline or Online"

topic in the Security Module/Engine Management chapter in the

d) Continue with Step 3.

Step 3

To remove a network module from the chassis, loosen the captive screw on the lower left side of the network module

and pull out the handle that is connected to the screw. This mechanically ejects the network module from the slot.

Figure 1: Remove the Network Module

for more information about the power switch.

OIR Failed

for more information about the power switch.

Install, Remove, and Replace the Network Module

, reboot the chassis. See the "Rebooting the Firepower 4100/9300

Online

FXOS Configuration Guide

Installation, Maintenance, and Upgrade

for your software version.