Cisco Firepower 4150 Manual - Halaman 22

Jelajahi secara online atau unduh pdf Manual untuk Perangkat Keras Jaringan Cisco Firepower 4150. Cisco Firepower 4150 26 halaman. Rack-mount and ground the chassis
Juga untuk Cisco Firepower 4150: Panduan Pemeliharaan dan Peningkatan (20 halaman), Manual (36 halaman), Manual (8 halaman), Manual (42 halaman), Memulai (42 halaman)

Halaman Cetak

Install the FIPS Opacity Shield

Step 3

Secure the clamp:

a) Plug in the power supply power cord and wrap the clamp around the over mold portion of the power cord.

b) Squeeze the clamp ends together to the power supply so that the annular teeth engage with the mate on the clamp.

c) Make sure the clamp fits snugly into the over mold.

d) Adjust the clamp position on the tie wrap so that the clamp is tight against the front of the over mold and the power

cord cannot be removed by lightly pulling on it.

Figure 14: Clamp on Over Mold of Power Cord

Power cord

Tie clamp annular teeth

Clamp release tabs

Step 4

If you need to remove the power cord, push the release tab on the clamp to force the annular clamp teeth to disengage

and the clamp opens up. You can then remove the clamp from the power cord.

Install the FIPS Opacity Shield

Caution

This procedure should be performed only by the Crypto Officer.

Note

Because the FIPS opacity shield covers the serial number on the chassis, you need to copy the serial number

on a label and attach it to the chassis where it can be retrieved or viewed easily before you install the FIPS

opacity shield. You need the serial number when you call Cisco TAC.

Before you begin

You need the following to install the FIPS opacity shield:

Installation, Maintenance, and Upgrade

Power cord over mold

Direction to squeeze the clamp tabs

—