Digitrax DZ123MK1 Panduan Memulai Cepat - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Konverter Media Digitrax DZ123MK1. Digitrax DZ123MK1 8 halaman. Z scale fits marklin z 88584

Halaman Cetak

Changing the Decoder Address

The first CV most people change is the decoder address. This allows you to

independently control each loco with a unique address. Digitrax decoders are

shipped with CV01 (AD2), the two digit address, set to 03. Following is a brief

description of how to change the decoder address with a Digitrax DT series

throttle. See your Starter Set Manual for complete programming instructions.

1. Place the loco on the programming track. Go into Program Mode on your system.

On DT400/DT402 press PROG. On DT300, DT100 & DT200 press RUN/STOP &

FN/F0.

2. Choose AD2 for 2 digit addressing or AD4 for 4 digit addressing (DT400/DT402

and DT300). (Ad for DT100 & DT200, see set manual for 4 digit instructions).

3. Choose the address you want to set up for the decoder.

4. Complete address programming. On DT400/DT402 press ENTER. On DT300,

DT100 & DT200 press SEL.

Note: CV29 must also be programmed to enable 4 digit addressing, this is

done automatically by the DT400/DT402 & DT300 but not on earlier throttles.

Digitrax LocoMotion® system

Your locomotives look like the real thing, now you can make them run like the

real thing, too. Digitrax decoders incorporate torque compensation for smooth

as silk operation. You can also program CVs that control momentum, 3 step

and 128 step speed tables, switching speed, normal direction of travel,

scaleable speed stabilization and more to take full advantage of the Digitrax

LocoMotion

System.

Momentum-CV03 & CV04

Momentum is part of the LocoMotion

CV03 and deceleration by CV04. Both come from the factory set to 000. A

range of 000 to 031 is available for both accel and decel. Try CV03:003 and

CV04:000 as a starting point for experimenting with momentum.

Complete Train Control

Run Your Trains, Not Your Track!

www.digitrax.com

System. Acceleration is controlled by