Digitrax SoundFX SDXN146K2 Manual - Halaman 10

Jelajahi secara online atau unduh pdf Manual untuk Konverter Media Digitrax SoundFX SDXN146K2. Digitrax SoundFX SDXN146K2 12 halaman.

SDXN146K2 Troubleshooting

If the sound does not start in the decoder

Make sure you have selected the locomotive address on a throttle.

The sound will not run unless the locomotive is addressed in the

system.

2. Check your installation to make sure the decoder is installed

properly.

If the sound output sounds distorted

Check the speaker cone for magnetic debris that may have collected

there. Debris on the speaker will cause a loss of sound quality and

must be removed.

2. Be sure that the CV58 volume is not set at a level that is too high for

the speaker being used.

If the sound in your decoder shuts down after you stop it and

you are not using a Digitrax system for control. On some DCC

systems decoders are not addressed by DCC packets after the locomotive

is set to 0 speed. In this case after the CV11 timeout elapses (6 second

default), sound will "shutdown.". To defeat this feature, set CV11=00 to

remove the timeout and shutdown. To make sounds, the decoder must

have a command addressed to it at least once.

If you have trouble reading back CVs on the programming

track, this may be due to insufficient current draw. Of course you can

always just re-program the CV value into a CV to get the desired results,

even if reading CVs does not work. OPS mode is recommended for writ-

ing to (programming) all CVs except CV01, CV17 & CV18 (2 digit and 4

digit addresses). If a second DCC decoder is present that is not SoundFX

compatible then correct read back of CV data is not possible, since the

NMRA CV read back was not designed for multiple decoder read back.

SDXN146K2

The

Diesel scheme. If the factory scheme has not been erased, program

CV60 to a value of 0 to reselect the default GP38 diesel scheme.

plays a Steam scheme, but I want the default

— 10 —