Digitrax SDH164K1C Panduan Pengguna - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Pengontrol Digitrax SDH164K1C. Digitrax SDH164K1C 12 halaman. Plug ‘n play for kato f40ph ho

Halaman Cetak

shipped with CV01 (AD2), the two digit address, set to 03. Following is a brief

description of how to change the decoder address with a Digitrax DT series

throttle. See your Starter Set Manual for complete programming instructions.

1. Place the loco on the programming track. Go into Program Mode on your system.

On DT400/DT402 press PROG. On DT300, DT100 & DT200 press RUN/STOP &

FN/F0.

2. Choose AD2 for 2 digit addressing or AD4 for 4 digit addressing (DT400/DT402

and DT300). (Ad for DT100 & DT200, see set manual for 4 digit instructions).

3. Choose the address you want to set up for the decoder.

4. Complete address programming. On DT400/DT402 press ENTER. On DT300,

DT100 & DT200 press SEL.

Note: CV29 must also be programmed to enable 4 digit addressing, this is

done automatically by the DT400/DT402 & DT300 but not on earlier throttles.

Using this decoder in other locomotives

The sound project loaded into this decoder is for an F40PH diesel locomotive.

If you want to install it in a different locomotive, you can simply load a dif-

ferent sound project for that type of locomotive. The cam input is available

for steam installations where you want to synchronize chuffing.

Digitrax LocoMotion

Your locomotives look like the real thing, now you can make them run like the

real thing, too. Digitrax decoders incorporate torque compensation for smooth

as silk operation. You can also program CVs that control momentum, 3 step

and 128 step speed tables, switching speed, normal direction of travel,

scaleable speed stabilization and more to take full advantage of the Digitrax

LocoMotion System.

Momentum-CV03 & CV04

Momentum is part of the LocoMotion System. Acceleration is controlled by

CV03 and deceleration by CV04. Both come from the factory set to 000. A

range of 000 to 031 is available for both accel and decel. We recommend that

you try CV03:003 and CV04:000 as a starting point for experimenting with

momentum.

Speed Tables-How the Loco Responds to the Throttle

With Digitrax LocoMotion, there are two types of speed tables: 3 Step Tables

and High Resolution 28 Step Tables. Please see your Digitrax Decoder Manual

for a discussion of the 28 Step Tables. The 3 Step Tables are set up by program-

ming 3 CVs: Start Voltage (CV02), Mid point Voltage (CV06) and Max Voltage

(CV05). These values are set at 000 at the factory. All have a range of values

from 000 to 255. We recommend the following CV values as a starting point for

2443 Transmitter RD

Panama City, FL 32404

www.digitrax.com

System

www.digitrax.com

850-872-9890

850-872-9557