Digitrax DZ125IN Manual - Halaman 4

Jelajahi secara online atau unduh pdf Manual untuk Mainan Digitrax DZ125IN. Digitrax DZ125IN 12 halaman. N scale mobile decoder 1 amp/1.25 amp peak 2 fx3 functions, 0.5 amp with 6 pin nem 651 type plug fit kato n-emd class 66 and others

Halaman Cetak

DZ125IN is factory default programmed to address 03. You can easily cus-

tomize the address and other features. See section "Customizing Your

Decoder" that

Installation Notes:

1. Do not exceed the decoder's 500mA total function output rating.

2. We recommend that the Blue wire, also called +Common or Lamp

Common, be connected as shown. If you wish to omit the Blue wire in your

installation, consult the Digitrax Decoder Manual for more information.

3. The head lamp should be hooked up using the Blue/+Common wire for

optimal Digitrax transponding operation.

4. To use a function output with an inductive (coil) type load, see the Digitrax

Decoder Manual for more information to avoid damage to the decoder.

5. See the Digitrax Decoder Manual for full details of wiring 12-16V lamps,

1.5V lamps, and LEDs. Lamps that draw more than 80 mA when running

require a 22 ohm 1/4 watt resistor in series with the directional light func-

tion lead to protect the decoder.

6. Some locomotives employ filter capacitors for RFI suppression in the loco-

motive wiring. These may cause problems with Supersonic decoders and

non-decoder analog operation on DCC. This capacitor should be removed

for safe operation.

C C u u s s t t o o m m i i z z i i n n g g Y Y o o u u r r D D e e c c o o d d e e r r

Your Digitrax decoder is ready to run and will operate using address 03 with no

Loco Type

Switcher

Concentrated low speed. Limited top

speed

Road Switcher

Prototypical top speed w/evenly

distributed curve from 0 to top speed

Mainline Loco

Quick increase to cruising speed then

levels off to prototypical top speed.

additional programming. For a more prototypical railroading experience, your

decoder can be customized for your specific locomotive by programming some

of the Configuration Variables, or CVs, available. See the Digitrax Decoder

Manual or the Digitrax web site for more information.

C C h h a a n n g g i i n n g g t t h h e e D D e e c c o o d d e e r r A A d d d d r r e e s s s s

The first CV most people change is the decoder address. This allows you to

D D

C C

i i g g i i t t r r a a x x

o o m m m m a a n n d d

R R u u n n Y Y o o u u r r T T r r a a i i n n s s , , N N o o t t Y Y o o u u r r T T r r a a c c k k ! !

www.digitrax.com

C C

o o n n t t r r o o l l

V Start

V Mid

CV02

CV06

002/x02

038/x26

002/x02

048/x30

002/x02

128/x80

V Max

CV05

064/x50

098/x62

154/x9A