argon audio SUB640 Panduan Pemilik - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Subwoofer argon audio SUB640. argon audio SUB640 7 halaman.

Halaman Cetak

Environmental information

Argon SUB640 Subwoofer complies with international

directives on the Restriction of Hazardous Substances

Electrical and Electronic Equipment (WEEE) - the crossed

bin symbol indicates compliance and that the products must

be appropriately recycled or processed in accordance with

these directives. (RoHS) in electrical and electronic

equipment and the disposal of Waste.

Safety instructions

Please store this instruction manual for future reference.

Do not use this product near water or moisture. Clean only

with a dry cloth. Unplug this product from the wall outlet

before cleaning. Place the unit on a solid surface. Do not

block any ventilation openings. Do not put it in a closed

bookcase or a cabinet that may keep air from flowing

through its ventilation openings. Do not install near any heat

sources, such as radiators, heat registers, stoves or other

appliances that produce heat. Protect the power cord from

being walked on or pinched, particularly at plugs and the

point where they exit from the product. Servicing is required

when the product has been damaged. Do not attempt to

service this product yourself. Opening or removing covers

may expose you to dangerous voltages or other hazards.

Please contact the manufacturer to be referred to an

authorized service center near you. To prevent risk of fire or

electric shock, avoid over loading wall outlets, extension

w w w . a r g o n a u d i o . c o m

SUB640

cords, or integral convenience receptacles. Do not let

objects or liquids enter the product. Use proper power

sources. Plug the product into a proper power source, as

described in the operation instructions or as marked on the

product.

Rear panel and connections

Volume adjustment

Cross-over / Frequency adjustment

Phase adjustment

Low Level Output, for connection extra Subwoofer etc.

Sound input from audio source or from amplifier/av

reciever with pre-out or sub-out (1. priority use)

Speaker input from amplifier/av reciever. Should only be

used if there is no PRE-OUT or SUB-OUT available on

the amplifier/av-reciever.

LED indicator Blue = "on", red = "stand-by"

The unit will go into stand-by status if put on "AUTO", if

there is no signal input for 10 minutes. If in "ON" position

the Subwoofer will remain powered ON indefinitely.

On/Off function of the unit

Power cable

Fuse holder, if fuse needs to be replaced use only same

type and fuse value. IMPORTANT; remember to unplug

the power cable from mains socket before opening the

fuse holder.

See illustration on page 5 for explanation