Digitrax BDL162 Manual - Halaman 12

Jelajahi secara online atau unduh pdf Manual untuk Sensor Keamanan Digitrax BDL162. Digitrax BDL162 13 halaman. Loconet occupancy detector

• Connect the equipment into an outlet on a circuit different form that to

which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Note: Any modifications to the equipment not expressly approved by Digitrax

voids the user's authority to operate under and be in compliance with CFR 47

rules, as administered by the Federal Communication Commission. Digitrax

believes any conscientiously installed equipment following guidelines in this

manual would be unlikely to experience RFI problems.

Digitrax guarantees the BDL162 to be free from manufacturing defects for five

years from the date of purchase. These units are not user serviceable. If a

defect occurs, return the unit to Digitrax for service. Digitrax will repair or

replace BDL162s at our discretion at no charge to you for five years from pur-

chase date. This warranty excludes damage due to abuse, such as failure to

properly protect against input over current with a fuse or circuit breaker or

applying excessive input voltage to the unit.

Digitrax will make non-warranty repairs needed because of physical damage or

electrical abuse at fair and reasonable rates.

All warranties on Digitrax products are limited to refund of purchase price or

repair or replacement of Digitrax products at the sole discretion of Digitrax.

In the event that Digitrax products are not installed or used in accordance with

the manufacturer's specifications, any and all warranties either expressed or

implied are void. Except to the extent expressly stated in this section, there are

no warranties, express or implied, including but not limited to any warranties

of merchantability or fitness for a particular purpose.

Digitrax, Inc. reserves the right to make changes in design and specifications

and/or to make additions or improvements in its products without imposing any

obligations upon itself to install these changes, additions or improvements on

products previously manufactured.