Digitrax PM74 Manual

Jelajahi secara online atau unduh pdf Manual untuk Catu Daya Digitrax PM74. Digitrax PM74 8 halaman. Power manager with occupancy and transponding detection for 4 sub-districts

Halaman Cetak

PM74

Features:

▪

4 Power manager sub-districts (or DS sections), similar to PM42.

▪

Each DS section configurable for Auto-reverse or intelligent

short-circuit Power Management function.

▪

Each DS has Occupancy and Transponding detection capability.

▪

Occupancy usable by LocoNet compatible signal systems and e.g. PC-

based track state monitoring.

▪

Transponding provides mobile decoder Mainline Operations Mode

CV read/write programming on compatible Digitrax systems.

▪

Transponding identifies compatible Decoder addresses in each DS.

▪

All plug-in connectors for simple and easy installation and service.

▪

User defined as 4 DS reporting addresses in 2000+ DS range.

▪

Low-loss magnetic sensing of DCC track current.

▪

Easy setup with device Option Switches (OPSW) or LocoNet CV

programming.

▪

Configured to operate with DCS52, DCS100, DCS210, DCS210+,

DCS240 Command Stations, and DB210 and DB220 boosters.

▪

Optional Detection and Power status led connector for remote state

indication, compatible with e.g. LT5.

▪

Additional LocoNet Configuration modes using DT602 throttles.

Parts List

1 PM74 Power Manager

1 Instruction Sheet

1.0 PM74 Initial Setup.

To install the PM74 and begin using on your LocoNet layout.

Figure 1 shows the recommended connections to operate the PM74 on a

LocoNet layout, with several track connection types shown.

For initial testing, connect power from a compatible DCC booster track-bus

feed via the RA/RB terminals of the PM74's 2-pin track power plug.

When powered, the green ID LED should light and will briefly wink OFF at

about 2 secs as a 'heartbeat' showing the unit is powered and operational.

Additionally the ZN or Zone LED on the left front of the unit will light green,

showing DCC packets are being detected on the 2-pin RB terminal.

For best operation reliability an optional PS14 or similar DC 12V/300mA

Complete Train Control

Run Your Trains, Not Your Track!

Power Manager with Occupancy and Tran-

sponding detection for 4 sub-districts

— 1 —

4 4-pin DS plugs

1 2-pin Track power plug