Cisco PIX-515E Panduan Memulai Cepat - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Perangkat Keras Jaringan Cisco PIX-515E. Cisco PIX-515E 42 halaman. Security appliance
Juga untuk Cisco PIX-515E: Panduan Memulai Cepat (42 halaman)

Halaman Cetak
Cisco PIX-515E Panduan Memulai Cepat
To use the Startup Wizard to set up a simplified basic configuration on the security appliance, follow
these steps:
If you have not already done so, connect the inside Ethernet 1 interface of the security
Step 1
appliance to a switch or hub by using the Ethernet cable. To this same switch, connect a PC
for configuring the security appliance.
Configure your PC to use DHCP (to receive an IP address automatically from the security
Step 2
appliance), or assign a static IP address to your PC by selecting an address out of the
192.168.1.0 network. (Valid addresses are 192.168.1.2 through 192.168.1.254, with a mask of
255.255.255.0 and default route of 192.168.1.1.)
The inside interface of the security appliance is assigned 192.168.1.1 by default, so
Note
this address is unavailable.
Step 3
Check the LINK LED on the Ethernet 1 interface. When a connection is established, the LINK
LED on the Ethernet 1 interface of the security appliance and the corresponding LINK LED on
the switch or hub will become solid green.
Launch the Startup Wizard.
Step 4
a. On the PC connected to the switch or hub, launch an Internet browser.
b. In the address field of the browser, enter this URL: https://192.168.1.1/.
The security appliance ships with a default IP address of 192.168.1.1. Remember to
Note
add the "s" in "https" or the connection fails. HTTPS (HTTP over SSL) provides a
secure connection between your browser and the security appliance.
In the popup window that requires a username and password, leave both fields empty. Press
Step 5
Enter.
Click Yes to accept certificates. Click Yes for any subsequent certificates or authentication
Step 6
requests.
After ASDM starts, choose the Wizards menu, then choose Startup Wizard.
Step 7
Follow the instructions in the Startup Wizard to set up your security appliance.
Step 8
For information about any field in the Startup Wizard, click the Help button at the bottom of
the window.
7