Cisco RSP4+ Panduan Instalasi dan Konfigurasi - Halaman 17

Jelajahi secara online atau unduh pdf Panduan Instalasi dan Konfigurasi untuk Perangkat Keras Jaringan Cisco RSP4+. Cisco RSP4+ 20 halaman. Bootflash memory upgrade to 16mb

Halaman Cetak

To copy the rsp-boot image onto the bootflash, use the following series of commands:

Step 5

Router# copy tftp:rsp-boot-mz.121-5.T1 bootflash:rsp-boot-mz.121-5.T1

20575008 bytes available on device slot0, proceed? [confirm]

Address or name of remote host [1.1.1.1]?

Loading new.image from 1.1.1.1 (via Ethernet1/0):!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

[OK - 7799951/15599616 bytes]

CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC

CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC

Router#

In the preceding example, the exclamation points (!!!) appear as the file is downloaded, and

Note

the "C" characters signify calculation of the checksum, which is a verification that the file

has been correctly downloaded to bootflash.

Use the dir bootflash command to confirm that the image has been copied to Flash memory. The output

Step 6

should display the filename of the image you copied to Flash memory (rsp11-1 in the following

example):

Router# dir bootflash:

Directory of bootflash:/

7602176 bytes total (2511224 bytes free)

Router#

Step 7

To ensure that the new image is used as a bootloader, add the appropriate commands to the

configuration file. To modify the configuration file, use the configure terminal command, as follows:

Router# configure terminal

Enter configuration commands, one per line. End with CNTL/Z.

Specify that you are changing the bootloader image, and that it will load from bootflash. Then add the

Step 8

filename of the new bootloader image to be loaded from bootflash:

Router(config)# boot bootldr bootflash:rsp-boot-mz.121-5.T1

The bootloader command is automatically added to your running configuration.

To exit configuration mode, press Ctrl-Z.

Step 9

To save the configuration, copy the new configuration to nonvolatile random-access memory

Step 10

(NVRAM):

Router#

Router# copy running-config startup-config

The new bootloader image is saved in the startup-config.

78-12288-02

-rw-

5090824

Jan 01 2000 00:02:28

RSP4+ Bootflash Memory Upgrade to 16MB Installation and Configuration Guide

Loading and Configuring the Bootflash Image

rsp-boot-mz.121-5.T1