Cisco RSP7000 Panduan Instalasi dan Konfigurasi - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Instalasi dan Konfigurasi untuk Perangkat Keras Jaringan Cisco RSP7000. Cisco RSP7000 48 halaman. Upgrade kit in the cisco 7000 series routers
Juga untuk Cisco RSP7000: Menginstal (26 halaman)

Halaman Cetak

Jumpers

There are no user-conﬁgurable jumpers on the RSP7000.

LEDs

The two LEDs on the RSP7000 indicate the system and RSP7000 status. The normal LED is on

when the system is operational. During normal operation, the CPU halt LED should be off. The CPU

halt LED goes on only if the system detects a processor hardware failure.

Serial Ports

Two asynchronous serial ports on the RSP7000, the console and auxiliary ports, allow you to

connect external devices to monitor and manage the system. The console port is an Electronic

Industries Association/Telecommunications Industry Association (EIA/TIA)-232 receptacle

(female) that provides a data circuit-terminating equipment (DCE) interface for connecting a

console terminal.

Note

standard by the Electronic Industries Association (EIA) and Telecommunications Industry

Association (TIA).

The auxiliary port is an EIA/TIA-232 plug (male) that provides a data terminal equipment (DTE)

interface; the auxiliary port supports ﬂow control and is often used to connect a modem, a channel

service unit (CSU), or other optional equipment for Telnet management.

Installation Prerequisites

Before beginning any of these procedures, review the following sections to ensure that your

equipment conﬁguration meets the minimum requirements for the upgrade or replacement you will

perform, and that you have all the parts and tools you will need. Also, review safety and

ESD-prevention guidelines to help you to avoid injury or damage to the equipment.

If you are replacing the existing RSP7000, upload your current conﬁguration ﬁle to a remote server

before you remove the RSP7000 to avoid having to reenter all your current conﬁguration

information manually. To upload the ﬁle, you need access to a remote server. Refer to the section

"Saving and Retrieving the Conﬁguration File" on page 12, for instructions for uploading the ﬁle

and retrieving it after the new RSP7000 is installed.

Safety

This section lists safety guidelines you should follow when working with any equipment that

connects to electrical power or telephone wiring.

7000 Series Route Switch Processor (RSP7000) Installation and Configuration in the Cisco 7000 Series Routers

EIA/TIA-232 was known as recommended standard RS-232 before its acceptance as a

Installation Prerequisites