Cisco TelePresence ISDN Link Panduan Administrator - Halaman 16

Jelajahi secara online atau unduh pdf Panduan Administrator untuk Perangkat Keras Jaringan Cisco TelePresence ISDN Link. Cisco TelePresence ISDN Link 27 halaman. Isdn link

Halaman Cetak

Cisco TelePresence ISDN Link

Contents

Introduction

Example with ISDN PRI T1 mode

In this example the ISDN type is PRI and National ISDN type, the number is 8000, and the endpoint

is connected directly to the ISDN Link. There is no IP infrastructure and the endpoint must not be

registered to VCS when using this configuration.

Endpoint configuration

Use the Remote Control or Touch panel to configure.

Network 1 > Assignment = Manual

Network 1 > IPv4 > Address = 192.168.1.100

Network 1 > IPv4 > SubnetMask = 255.255.255.0

Network 1 > IPv4 > Gateway = 192.168.1.1

Conference 1 > DefaultCall > Protocol = SIP

Conference 1 > DefaultCall > Rate: 1472 (NI PRI 23 channels @ 64 kbps)

ISDN Link configuration

Use the serial port to configure.

xConfiguration Network 1 Assignment: Static

(Set Static IP)

xConfiguration Network 1 IPv4 Address: "192.168.1.101"

(Set the IP address of the ISDN Link)

xConfiguration Network 1 IPv4 SubnetMask: "255.255.255.0"

(Set the subnet mask of the ISDN Link)

xConfiguration Gateway SIP PeerHost: "192.168.1.100"

(Set the IP address of the endpoint)

xConfiguration H320 NetType: PRI

(Set type of ISDN)

xConfiguration ISDN PRI SwitchType: NI

(Set the ISDN switch type)

xConfiguration ISDN PRI Interface 1 MaxChannels: 23

(Set the MaxChannels to the number of channels you have)

xConfiguration ISDN PRI Interface 1 HighChannel: 23

(Set the HighChannel to the number of the highest channel)

xConfiguration ISDN PRI Interface 1 NumberRangeStart: "8000"

xConfiguration ISDN PRI Interface 1 NumberRangeStop: "8000"

(Enter your PRI number range, this MUST be according to the ISDN network configuration.)

D14954.01

ISDN Link Administrator Guide IL1.0, June 2012.

Getting started

Configuration examples

ISDN only

Dialling from the endpoint

From the endpoint you should now be able to dial an ISDN number using the following format:

Format: <ip address>;x-h320number=XXXX

• Where XXXX is the ISDN number you wish to call.

• In this case, with no IP infrastructure, we use the IP Address to identify the ISDN Link.

Example: 192.168.1.101;x-h320number=1234

Password protection

Appendices

EX90

ISDN Network

ISDN Link

Administrator guide