Epson 2580 - Perfection PHOTO Buletin Dukungan Produk - Halaman 28

Jelajahi secara online atau unduh pdf Buletin Dukungan Produk untuk Pemindai Epson 2580 - Perfection PHOTO. Epson 2580 - Perfection PHOTO 40 halaman. Scanning application force quits on mac os 10.4
Juga untuk Epson 2580 - Perfection PHOTO: Buletin Dukungan Produk (1 halaman), Panduan Pengguna (6 halaman), Catatan Rilis (1 halaman), Panduan Memulai Cepat (8 halaman), Buletin Dukungan Produk (23 halaman), Manual (11 halaman), Memperbarui (1 halaman), Buletin Dukungan Produk (24 halaman), Buletin Dukungan Produk (29 halaman), Buletin Dukungan Produk (8 halaman), Buletin Dukungan Produk (3 halaman), Buletin Dukungan Produk (14 halaman), Buletin Dukungan Produk (12 halaman), Buletin Dukungan Produk (40 halaman), Buletin Dukungan Produk (11 halaman), Buletin Dukungan Produk (40 halaman), Buletin Dukungan Produk (22 halaman), Buletin Dukungan Produk (12 halaman), Buletin Dukungan Produk (21 halaman)

Clicking on "Refresh List" brings up this Warning window again.

Solution:

Download the patch from Epson's Support Web site at http://support.epson.com. The Installer should find the location of

your Epson Smart Panel software and install the update automatically.

Run Setup.exe and the Install wizard will find the location of Epson Smart Panel software on your hard drive and prompt

you to continue. Click "Next." The Install wizard will then finish. Click "Finish" to complete the update and exit.

To verify the patch was successful, open Epson Smart Panel and click on the Light bulb icon in the upper left-hand

corner. Select "About" from the pull-down menu. You should see v.2.01P01E (see figure below).

Start the Scan to Email Utility and run through the steps again. You will now find that your Email Program shows up as a

registered application in the Launch Assistant window (see figure below).

After you select your Email Program, it will open with a "Compose New" window and your scanned file will be attached

to the Email. Enter an email address, a subject line, and some text in the body of the mail, and then click "Send".