Cisco WS-C6509 Panduan Pengguna - Halaman 9
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Perangkat Keras Jaringan Cisco WS-C6509. Cisco WS-C6509 28 halaman. Catalyst 6500 series
Juga untuk Cisco WS-C6509: Panduan Peningkatan (24 halaman), Lembar data (30 halaman)
Halaman Cetak
Table 1
LED
VPN Services Module
STATUS
1. The SYSTEM and PWR MGMT LED indications on a redundant supervisor engine are synchronized to the active
supervisor engine.
2. VTT = voltage termination module. The VTT module terminates signals on the Catalyst switching bus.
3. If no redundant supervisor engine is installed and there is a VTT module minor or major over-temperature condition, the
system shuts down.
4. Enter the show crypto eli command to determine whether the FIPS-related self-tests passed.
All of these physical interfaces are separated into the logical interfaces from FIPS 140-2 as described
in
Table
Table 2
Switch and Router Physical Interfaces
Ethernet ports
Network and service module interfaces
Console port
Compact flash (PCMCIA) slot
Ethernet ports
Network and service module interfaces
Console port
Compact flash (PCMCIA) slot
Ethernet ports
Network and service module interfaces
Console port
Reset button
Catalyst 6509 Switch, Cisco 7606 Router, and Cisco 7609 Router with VPN Services Module Certification Note
OL-6334-01
Catalyst 6509 Switch and Cisco 7606 and 7609 Router LEDs (continued)
Color/State Description
Green
All non-FIPS-related diagnostic tests pass. The module is
operational.
Red
A diagnostic test other than an individual port test failed.
Orange
Indicates one of three conditions:
•
•
•
Off
The module power is off.
2.
FIPS 140-2 Logical Interfaces
Catalyst 6509/Cisco 7606/Cisco 7609 Cryptographic Module
4
The module is running through its boot and self-test diagnostic
sequence.
The module is disabled.
The module is in the shutdown state.
FIPS 140-2 Logical Interface
Data input interface
Data output interface
Control input interface
9