Cisco 7513 Series Manual - Halaman 14

Jelajahi secara online atau unduh pdf Manual untuk Server Cisco 7513 Series. Cisco 7513 Series 30 halaman. Chassis replacement
Juga untuk Cisco 7513 Series: Panduan Memulai Cepat (44 halaman), Manual Petunjuk Penggantian (26 halaman), Lembar data (11 halaman), Mempertahankan (20 halaman), Manual Petunjuk Penggantian (19 halaman), Manual Petunjuk Penggantian (22 halaman)

Replacing or Upgrading the Chassis

Figure 5

POW ER

We recommend that two people perform this procedure: one person should support the chassis while

the other person removes the screws that secure the ears to the rack.

Warning

To prevent injury, have someone help you lift the chassis, as shown in Figure 6. To prevent damage to the air

intake vent below the card cage, do not lift the chassis by grasping the handle with one hand and the bottom

of the card cage with the other. Grasp the chassis as shown in Figure 6.

To remove the existing chassis from the rack, follow these steps:

Step 1

Step 2

Step 3

14 Cisco 7513 and Cisco 7576 Chassis Replacement and Upgrade Instructions

Chassis, Rack Brackets, and Ears

The chassis weighs approximately 75 pounds with just the blower module and card cage installed.

Turn off the system power and disconnect the power cable and all interface cables from

the chassis.

Use a screwdriver to loosen and remove each of the four screws (two on each side) that

secure the chassis ears to the rack rails.

Pull the chassis out of the rack and place it on the ﬂoor or a table.

M4 x 10-mm long

Phillips flat-head

screws (to attach

ears to chassis)

Bracket (2)

POW ER