Cisco 7513 Series Manual - Halaman 19

Jelajahi secara online atau unduh pdf Manual untuk Server Cisco 7513 Series. Cisco 7513 Series 30 halaman. Chassis replacement
Juga untuk Cisco 7513 Series: Panduan Memulai Cepat (44 halaman), Manual Petunjuk Penggantian (26 halaman), Lembar data (11 halaman), Mempertahankan (20 halaman), Manual Petunjuk Penggantian (19 halaman), Manual Petunjuk Penggantian (22 halaman)

We recommend that you refer to the "Port and Slot Conﬁguration Worksheet" section on

Note

page 28 before you remove interface processors from the old chassis. This will ensure that you

install them in the correct slots in the new chassis based on the conﬁguration stored in NVRAM on

the RSP.

Although interface processors support OIR, you must wait at least 15 seconds after inserting an

interface processor before inserting the next one. To help avoid errors with the installation, leave the

power off until you have moved all components into the new chassis and have veriﬁed that all of

them are installed properly.

Move the interface processors ﬁrst, one at a time, then move the RSPs last. Before you remove an

interface processor from the existing chassis, remove the interface processor ﬁller from the

corresponding slot in the new chassis. Then immediately install the interface processor in the new

chassis and secure it in the slot before removing the next interface processor ﬁller or module. If you

leave the interface cables attached to the interface processors, route the cables through the

cable-management brackets immediately after you secure the interface processor in the slot to help

keep the other slots clear during the installation.

If there is sufﬁcient slack in the interface cables, and if you can easily move the processor modules

between the chassis without straining the cables, leave the interface cables connected. If you must

disconnect the cables, label each cable with its slot and port number before you disconnect it. Do not

reconnect the interface cables until you have installed all of the components in the new chassis (it is

easier to install interface processors when the slots are not impeded by cables that drop from other

slots). Use the optional cable-management brackets to keep the interface cables untangled and away

from other interface processor slots and ports.

The Cisco 7513 and Cisco 7576 allow you to remove and replace interface processors and

Note

RSPs while the system is powered on; however, you must shut down the system power before

accessing the chassis interior for any other reason. If you intend to remove and replace an interface

processor or RSP while the system is powered on, do so only when no operations are taking place

that involve the RSPs NVRAM or ﬂash memory. This includes operations involving system

conﬁguration changes, and downloading microcode images.

Moving Processor Modules from the Old Chassis to the New Chassis

Cisco 7513 and Cisco 7576 Chassis Replacement and Upgrade Instructions