Cisco 7513 Series Mempertahankan - Halaman 9
Jelajahi secara online atau unduh pdf Mempertahankan untuk Server Cisco 7513 Series. Cisco 7513 Series 20 halaman. Chassis replacement
Juga untuk Cisco 7513 Series: Panduan Memulai Cepat (44 halaman), Manual Petunjuk Penggantian (26 halaman), Lembar data (11 halaman), Manual (30 halaman), Manual Petunjuk Penggantian (19 halaman), Manual Petunjuk Penggantian (22 halaman)
Halaman Cetak
Chapter 7
Maintaining Your Cisco 7513, Cisco 7513-MX, and Cisco 7576 Router
Installing the Card Cage Assembly
Use the following procedure to install the card cage assembly.
The electronic components on the rear of the backplane are completely exposed when the card cage and
Caution
backplane assembly is removed from the chassis. To prevent damaging these components, carefully slide
the assembly into the chassis opening.
Figure 7-7
Captive screw
Card cage
side flange
Captive screw
Air intake grill
Carefully lift the card cage assembly, place it into the chassis opening, and slide the assembly into the
Step 1
chassis opening until the left and right flanges on the card cage are flush with the chassis flanges.
Squeeze the card cage and chassis flanges together, and tighten each captive screw. Do not overtighten
Step 2
the captive screws.
Carefully replace the processor modules in the card cage. (See the procedure shown in
Step 3
Reinstall the power supplies in the Cisco 7513, Cisco 7513-MX, or Cisco 7576. (See the
Step 4
Cisco 7513, Cisco 7513-MX, and Cisco 7576 Power Supplies" section on page
This completes the procedure for installing the card cage assembly in the Cisco 7513,
Cisco 7513-MX, and Cisco 7576.
OL-5008-03 B0
Maintenance Procedures for the Cisco 7513, Cisco 7513-MX, and Cisco 7576
Installing the Card Cage Assembly
POW ER
A
Captive screw
Card cage
side flange
Captive screw
POW ER
B
Cisco 7500 Series Installation and Configuration Guide
Figure
3-14.)
"Installing
3-27.)
7-9