Cisco AS5200 - Universal Access Server Catatan Rilis - Halaman 11
Jelajahi secara online atau unduh pdf Catatan Rilis untuk Server Cisco AS5200 - Universal Access Server. Cisco AS5200 - Universal Access Server 22 halaman. Universal access server
Juga untuk Cisco AS5200 - Universal Access Server: Panduan Memulai Cepat (20 halaman)
Halaman Cetak
New Software Features in Cisco IOS Release 11.2(6) P through 11.2(9) P
There are no new software features supported by the Cisco AS5200 in Cisco IOS Release 11.2(6) P
though Release 11.2(9) P.
New Software Features in Cisco IOS Release 11.2(5) P
The following new feature is supported by the Cisco AS5200 only and are available in Cisco IOS Release
11.2(5) P and later.
Channelized E1 Signaling for the Cisco AS5200
Cisco IOS Release 11.2(5) P and later support channel-associated signaling for channelized E1 lines,
which are commonly deployed in networks in Latin America, Asia, and Europe.
After this feature is configured on a single E1 controller, up to 30 remote users can simultaneously dial
in to the Cisco AS5200 through networks running the R2 protocol. Typically, all 30 channels of a
channelized E1 line are used for analog calls. However, a signal converter is still needed to perform
conversions between R2 signaling and ear and mouth signaling (also known as E&M). Because the
Cisco AS5200 has two physical E1 ports on its dual E1 Primary Rate Interface (PRI) board, up to 60
simultaneous connections can be made through the dual E1 PRI board.
These service adapters provide high-performance, hardware-based data compression capabilities via
simultaneous stacker compression data compression algorithms with independent full-duplex
compression and decompression capabilities on Point-to-Point Protocol (PPP) encapsulated packets.
For step-by-step software configuration information, refer to the feature module Channelized E1
Note
Signaling for the Cisco AS5200, which is published in the Feature Guide for Cisco IOS Release 11.2
P. For instructions on how to reach this publication via Cisco.com or the Documentation CD-ROM,
refer to the
New Software Features in Cisco IOS Release 11.2(3) P through 11.2(4) P
There are no new software features supported by the Cisco AS5200 in Cisco IOS Release 11.2(3) P
through Release 11.2(4) P.
New Features in Cisco IOS Release 11.2(1) P through 11.2(2) P
The following new features are supported by the Cisco AS5200 only and are available in
Cisco IOS Release 11.2(1) P and later.
Robbed-Bit Signaling for the Cisco AS5200
Ground-start and loop-start signaling was provided for channelized T1. This new signaling is set using
the cas-group controller configuration command.
78-5214-15 Rev. A0
"Related Documentation" section on page
Release Notes for Cisco AS5200 Universal Access Servers for Cisco IOS Release 11.2 P
New and Changed Information
14.
11