Cisco AS5300 - Universal Access Server Panduan Konfigurasi - Halaman 16
Jelajahi secara online atau unduh pdf Panduan Konfigurasi untuk Server Cisco AS5300 - Universal Access Server. Cisco AS5300 - Universal Access Server 46 halaman. Access server
Juga untuk Cisco AS5300 - Universal Access Server: Lampiran (10 halaman), Panduan Memulai Cepat (25 halaman), Manual (21 halaman)
Halaman Cetak
Task 2—Setting Up Asynchronous Shell Services
0 output buffer failures, 0 output buffers swapped out
3 carrier transitions
Timeslot(s) Used:24, Transmitter delay is 0 flags
The term "spoofing" means that the interface is presenting itself to the Cisco IOS software as up and
operational. This interface can now receive routes. There are 23 more channels behind this interface that
you do not see (for example, S0:0, S0:1, and so on). The D channel decides which serial channel
(B channel) to assign to an incoming call.
Note
Enter the show isdn status command to view the ISDN layer information.
Step 2
This output shows that Layer 1 and Layer 2 are enabled and active and that there are no active Layer 3
ISDN calls.
hq-sanjose# show isdn status
The current ISDN Switchtype = primary-ni
ISDN Serial0:23 interface
Layer 1 Status:
Layer 2 Status:
Layer 3 Status:
Activated dsl 0 CCBs = 0
Total Allocated ISDN CCBs = 0
ISDN Serial1:23 interface
Layer 1 Status:
Layer 2 Status:
Layer 3 Status:
Activated dsl 1 CCBs = 0
Total Allocated ISDN CCBs = 0
ISDN Serial2:23 interface
Layer 1 Status:
Layer 2 Status:
Layer 3 Status:
Activated dsl 2 CCBs = 0
Total Allocated ISDN CCBs = 0
ISDN Serial3:23 interface
Layer 1 Status:
Layer 2 Status:
Layer 3 Status:
Activated dsl 3 CCBs = 0
Total Allocated ISDN CCBs = 0
Note the following information:
Layer 1 Status should be "Active."
•
Cisco IOS Dial Services Quick Configuration Guide
2-16
The packet counters shown by the interface serial 0:23 command are for
signalling traffic only. Data traffic passes through S0:0 through S0:22.
ACTIVE
TEI = 0, State = MULTIPLE_FRAME_ESTABLISHED
No Active Layer 3 Call(s)
ACTIVE
TEI = 0, State = MULTIPLE_FRAME_ESTABLISHED
No Active Layer 3 Call(s)
ACTIVE
TEI = 0, State = MULTIPLE_FRAME_ESTABLISHED
No Active Layer 3 Call(s)
ACTIVE
TEI = 0, State = MULTIPLE_FRAME_ESTABLISHED
No Active Layer 3 Call(s)
Chapter 2
Configuring the Cisco AS5300 Network Access Server