Cisco expressway ce1100 Panduan Instalasi - Halaman 10

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Server Cisco expressway ce1100. Cisco expressway ce1100 20 halaman.

Cisco Expressway CE1100 Appliance Installation Guide

Configure

This section describes the different ways you can connect to the Cisco Expressway and perform the initial

configuration.

Before you can use the Cisco Expressway, you must configure its IPv4 and/or IPv6 address, subnet mask, default

gateway and set the root and admin password. You can also choose to enable the web UI and SSH access. Consult

your network administrator for information on which addresses to use. Note that the Cisco Expressway must use a

static IP address.

Note:

An additional IP address is required if the Cisco Integrated Management Controller (CIMC) tool is used. It can be

a static IP address or assigned using DHCP.

For initial configuration, use any of these methods:

Connect a PC to the Cisco Expressway using a serial cable (see

■

followed by

Connect a monitor and keyboard directly into the unit (see

■

Configure the Cisco Expressway, page

Connect using the CIMC port ( see

■

Serial Using the CIMC, page

Figure 1 Rear Panel Showing Ports

Table 3 Rear Panel Ports

LAN 1 (left-hand SFP port)

LAN 2 ( right-hand SFP port)

Modular LAN-on-motherboard (MLOM) card slot

USB 3.0 port

CIMC port

Serial Port (RJ-45 connector)

Configure the Cisco Expressway, page

Connect Using the CIMC Port, page 12

13).

Connect Using the Serial Port, page 11

13).

Connect Using the KVM Port, page 12

13).

followed by

Remotely Connect to