Cisco Firepower 2130 Memulai - Halaman 23

Jelajahi secara online atau unduh pdf Memulai untuk Server Cisco Firepower 2130. Cisco Firepower 2130 42 halaman. Rack-mount and ground the chassis
Juga untuk Cisco Firepower 2130: Manual (12 halaman), Panduan Penyebaran (8 halaman), Instalasi & Pemeliharaan (26 halaman)

Halaman Cetak

Getting Started

Complete the Initial Configuration Using the Setup Wizard

When you initially log into the FDM, you are taken through the device setup wizard to complete the initial

system configuration.

If you plan to use the device in a high availability configuration, please read

Availability.

Note

Before you begin

Ensure that you connect a data interface to your gateway device, for example, a cable modem or router. For

edge deployments, this would be your Internet-facing gateway. For data center deployments, this would be a

back-bone router. Use the default "outside" interface for your model (see

and

Default Configuration Prior to Initial Setup, on page

Then, connect your management computer to the "inside" interface for your hardware model. Alternatively,

you can connect to the Management interface. For the FTDv, simply ensure that you have connectivity to the

management IP address.

(Except for the FTDv, which requires connectivity to the internet from the management IP address.) The

Management interface does not need to be connected to a network. By default, the system obtains system

licensing and database and other updates through the data interfaces, typically the outside interface, that

connect to the internet. If you instead want to use a separate management network, you can connect the

Management interface to a network and configure a separate management gateway after you complete initial

setup.

To change the Management interface network settings if you cannot access the default IP address, see

Change Management Network Settings at the CLI, on page

Procedure

Step 1

Log into the FDM.

a) Assuming you did not go through initial configuration in the CLI, open the FDM at https://ip-address,

where the address is one of the following.

b) Log in with the username admin. The default admin password is Admin123. On AWS, the default admin

password for the FTDv is the AWS Instance ID, unless you define a default password with user data

(Advanced Details > User Data) during the initial deployment..

Step 2

If this is the first time logging into the system, and you did not use the CLI setup wizard, you are prompted

to read and accept the End User License Agreement and change the admin password.

The Firepower 4100/9300 and ISA 3000 do not support the setup wizard, so this procedure does not apply to

these models. For the Firepower 4100/9300, all initial configuration is set when you deploy the logical device

from the chassis. For the ISA 3000, a special default configuration is applied before shipping.

• If you are connected to the inside interface: https://192.168.95.1.

• (the FTDv) If you are connected to the Management interface: https://192.168.45.45.

• (All other models) If you are connected to the Management interface: https://dhcp_client_ip

Complete the Initial Configuration Using the Setup Wizard

Prepare the Two Units for High

Connect the Interfaces, on page 12

26).

21.

Getting Started

(Optional)