Cisco Nexus 7000 Series Panduan Memulai Cepat - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Server Cisco Nexus 7000 Series. Cisco Nexus 7000 Series 10 halaman. Switch chassis
Juga untuk Cisco Nexus 7000 Series: Panduan Referensi (2 halaman), Panduan Petunjuk Instalasi (39 halaman), Referensi (34 halaman), Panduan Instalasi (18 halaman), Mengkonfigurasi (8 halaman), Panduan Konfigurasi (28 halaman), Panduan Memulai Cepat (29 halaman), Manual Petunjuk Penggantian (14 halaman), Manual Petunjuk Penggantian (21 halaman), Panduan Instalasi (16 halaman), Panduan Pemecahan Masalah (10 halaman)

Replacing a DIMM on an I/O Module

Follow ESD procedures, which include wearing an ESD wrist strap and placing

Step 1

antistatic foam or antistatic padding where you will place the I/O module while

working with it. Choose a location that prevents damage to the module while it is

outside the chassis.

Disconnect each I/O cable and remove the SFP transceivers from the front of the

Step 2

module to be removed.

Invisible laser radiation may be omitted from disconnected fibers or

Warning

connectors. Do not stare into beams or view directly with optical instruments.

Statement 1051

Completely unscrew both captive screws on the installed I/O module that you

Step 3

need to upgrade.

Step 4

Press both ejector release buttons on the ends of the module to push out the ejector

levers and to disconnect the module.

Simultaneously rotate the two ejector levers outward to unseat the module from

Step 5

the midplane connector.

With a hand on each ejector, pull the module part way out of its slot in the chassis.

Step 6

Grasp the front edge of the module and place your other hand under the module

Step 7

to support its weight. Pull the module out of its slot.

To prevent ESD damage, avoid touching the electronic circuitry and prevent

Caution

anything else from coming in contact with its circuitry.

If you are removing the module from a Cisco 7010 chassis, rotate the module 90

Step 8

degrees counterclockwise so that it is horizontal and you can see the circuitry

from above.

If there is a metal cover on the back of the I/O module, remove all 14 screws

Step 9

holding the metal cover in place and remove the metal cover before proceeding to

the next step. See

Replacing Memory on a Cisco Nexus 7000 Series I/O Module

Figure

78-100406-01