Cisco ONS 15600 Panduan Petunjuk Instalasi
Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Server Cisco ONS 15600. Cisco ONS 15600 14 halaman. Install the bay and backplane connections
Juga untuk Cisco ONS 15600: Mengubah Pengaturan Kartu (14 halaman), Panduan Referensi (29 halaman), Manual (10 halaman), Panduan Referensi (22 halaman)
Halaman Cetak
Install the Bay and Backplane Connections
This chapter provides procedures for installing the Cisco ONS 15600. To view a summary of the tools
and equipment required for installation, see the
Before You Begin
This section lists the chapter procedures (NTPs). Turn to a procedure for applicable tasks (DLPs).
Perform these procedures in the order they appear.
1.
2.
3.
4.
5.
6.
7.
8.
9.
Warning
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030
Warning
This unit is intended for installation in restricted access areas. A restricted access area can be
accessed only through the use of a special tool, lock and key, or other means of security.
Statement 1017
78-17203-01
NTP-E1 Unpack and Inspect the ONS 15600 Bay Assembly, page
before continuing with the
NTP-E2 Install the Bay Assembly, page
NTP-E3 Open and Remove the Front Door, page
equipment before continuing with other procedures in this chapter.
NTP-E104 Install Cable Routing Modules and Kick Plates, page
remove the existing cable routers and install the cable routing modules (CRMs).
NTP-E4 Install the Bay Power and Ground, page
with the
"NTP-E5 Remove the Rear Cover" procedure on page
NTP-E5 Remove the Rear Cover, page
"NTP-E6 Install Wires to Alarm, Timing, LAN, and Craft Pin Connections" procedure on
page
1-11.
NTP-E6 Install Wires to Alarm, Timing, LAN, and Craft Pin Connections, page
needed to set up connections on the backplane.
NTP-E8 Replace the Rear Cover, page
NTP-E7 Perform the Bay Installation Acceptance Test, page
determine if you have correctly completed all other procedures in the chapter.
"Required Tools and Equipment" section on page
"NTP-E2 Install the Bay Assembly" procedure on page
1-5—Complete this procedure to install the bay assembly.
1-6—Complete this procedure to access the
1-9—Complete this procedure before continuing
1-11—Complete this procedure before continuing with the
1-12—Complete as needed to install the rear cover.
C H A P T E R
1-4—Complete this procedure
1-8—Complete as needed to
1-11.
1-11—Complete as
1-13—Complete this procedure to
Cisco ONS 15600 Procedure Guide, R7.0
1
1-2.
1-5.
1-1