B2 Audio MANI 600D21 Panduan Pengguna - Halaman 8

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Penguat B2 Audio MANI 600D21. B2 Audio MANI 600D21 12 halaman.

sPeaker connection

mani 600.4- BRIDGE MODE

We recommend using minumum12 Ga speaker cables to acquire the intended performance & e ciency.

Run the speaker cables from your speakers to the ampli er's mounting location.

Ensure these are ran separately and away from high current cables and if possible the RCA cables as well.

In all cases where cables are penetrating the vechile's chassis use grommets to protect the cable.

Connect the speaker wires according to the terminals on the speaker(s). Strip 3/8'' / 1 cm of insulation of the end of

each cable and twist the cable strands together tightly. Make sure there are no stray strands that could touch other

cables or terminals as it can cause a short circut.

Crimp spade plugs over the end of the cable or tin the ends with solder to provide a solid terminal.

Connect the cable ends to the ampli er as shown in the diagram. Bridged speaker connection will add the channels

together. Bridged speaker connection impedance is 4 ohm only !

16 V

SPEAKER IMPEDANCE 4 OHM ~ 8 OHM

will reach thermal at a faster rate & will eventually go into protect.

Impedance load under 4 ohm is not warranted!