Cisco SNS-3415 series Panduan Instalasi - Halaman 12
Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Server Cisco SNS-3415 series. Cisco SNS-3415 series 19 halaman. Sns-3400 series
Juga untuk Cisco SNS-3415 series: Panduan Instalasi (36 halaman), Panduan Pemecahan Masalah (8 halaman)
Halaman Cetak
Connecting and Powering On the Cisco SNS-3415/3495 Appliance
Amber—The server is in standby power mode. Power is supplied only to the CIMC and some
•
motherboard functions.
•
Green—The server is in main power mode. Power is supplied to all server components.
During bootup, the server beeps once for each USB device that is attached to the server. Even if there
Note
are no external USB devices attached, there is a short beep for each virtual USB device such as a virtual
floppy drive, CD/DVD drive, keyboard, or mouse. A beep is also emitted if a USB device is hot-plugged
or hot-unplugged during BIOS power-on self test (POST), or while you are accessing the BIOS Setup
utility or the EFI shell.
Connect a USB keyboard and VGA monitor by using the supplied KVM cable connected to the KVM
Step 2
connector on the front panel (see
Alternatively, you can use the VGA and USB ports on the rear panel. However, you cannot use the front
Note
panel VGA and the rear panel VGA at the same time. If you are connected to one VGA connector and
you then connect a video device to the other connector, the first VGA connector is disabled.
Step 3
See the
Use this utility to set NIC mode, NIC redundancy, and choose whether to enable DHCP or set static
network settings.
Connect to the CIMC for server management. Connect Ethernet cables from your LAN to the server,
Step 4
using the ports that you selected in Step 3. The Active-active and Active-passive NIC redundancy
settings require you to connect to two ports.
Enter the IP address of the CIMC in your browser to connect to the CIMC Setup Utility. The CIMC IP
Step 5
address is configured in Step 3 (either a static address or the address assigned by your DHCP server).
To manage the server, see the Cisco UCS C-Series Rack-Mount Server Configuration Guide or the Cisco
UCS C-Series Rack-Mount Server CLI Configuration Guide for instructions on using those interfaces.
The links to these documents are in the C-Series documentation roadmap:
http://www.cisco.com/go/unifiedcomputing/c-series-doc
Installation and Upgrade Guide for Cisco Secure Access Control System 5.6
8-12
Figure
"Configuring CIMC" section on page 8-5
Chapter 8
Installing the Cisco SNS 3415 and Cisco SNS 3495 Hardware Appliances
6-1).
to enter in to the BIOS CIMC Configuration Utility.