Cisco SNS-3595 series Panduan Pemasangan Perangkat Keras - Halaman 39
Jelajahi secara online atau unduh pdf Panduan Pemasangan Perangkat Keras untuk Server Cisco SNS-3595 series. Cisco SNS-3595 series 41 halaman. Sns 3500 series
Juga untuk Cisco SNS-3595 series: Manual (41 halaman), Panduan Pemecahan Masalah (8 halaman)
Halaman Cetak
Install the Cisco SNS 3515 and Cisco SNS 3595 Hardware Appliances
In addition, Cisco ISE runs on Cisco Secure Network Server 3515 and Cisco Secure Network Server 3595
hardware appliances with Cisco Secure Access Control System (Cisco Secure ACS) PIDs. However, before
you install Cisco ISE on an SNS-3500 server that was previously used for Cisco Secure ACS, you must
upgrade the BIOS and Cisco Integrated Management Controller (Cisco IMC) firmware to a version that
supports the Cisco ISE secure boot capability.
After you upgrade the BIOS, secure boot is enabled and ACS will no longer boot on this appliance. Do
Note
not perform this BIOS upgrade procedure until you are ready to convert the appliance from ACS to ISE.
Before You Begin
Download the following Cisco IMC and BIOS files for the Cisco SNS-3500 series appliance from
to your local system:
• BIOS: C220M4-BIOS-3-0-3a-0_ISE2a.cap_signed
• Cisco IMC: upd-pkg-c220-m4-cimc-full.3.0.3S2.bin
The following procedure is for upgrading the BIOS and Cisco IMC to version 3.0(3a). However, this
Note
procedure is generic and is applicable for newer firmware releases that are posted on Cisco.com.
Step 1
Update the Cisco IMC firmware:
a) In the Cisco IMC interface, choose Admin > Firmware Management.
b) From the Actions pane, select the Check Install Cisco IMC Firmware through Browser Client option.
c) In the Install Cisco IMC Firmware window, click Browse and select the firmware image to install, and then click
Install Firmware to begin download and installation.
After the installation is fully completed, the status changes to Completed Successfully. The image replaces the
nonactive image.
Step 2
Update the BIOS firmware:
a) In the Cisco IMC interface, choose Admin > Firmware Management.
b) From the Actions pane, select the Install BIOS Firmware through Browser Client option.
c) In the Install BIOS Firmware window, click Browse and select the BIOS firmware image to install and then click
Install Firmware to begin download and installation.
After the installation is fully completed, the status changes to Completed Successfully.
Step 3
Activate the Cisco IMC firmware:
a) In the Cisco IMC interface, choose Admin > Firmware Management > Activate Cisco IMC Firmware.
b) In the Activate Firmware window, select the firmware image to activate.
Activating a firmware image makes it the running version. The management controller is rebooted immediately to
complete the activation.
Communication with the controller is temporarily lost and you should log in
Note
again.
c) After Cisco IMC is restarted, refresh the browser and enter your credentials in the Cisco IMC 3.0(3S2) login page.
Upgrade the BIOS and Cisco IMC Firmware
Cisco SNS 3500 Series Appliance Hardware Installation Guide
Cisco.com
35