Cisco UCS B260 M4 Catatan Instalasi dan Layanan - Halaman 27

Jelajahi secara online atau unduh pdf Catatan Instalasi dan Layanan untuk Server Cisco UCS B260 M4. Cisco UCS B260 M4 46 halaman. Blade server
Juga untuk Cisco UCS B260 M4: Catatan Instalasi dan Layanan (50 halaman)

Halaman Cetak

Cisco UCS B260 M4 Catatan Instalasi dan Layanan

Servicing the Blade Server

• A squeeze-to-remove retaining clip is provided to secure the internal USB flash memory. The clip

Note

• Use of this server may require an upgrade to the FEX in the chassis. The Cisco 2104XP fabric

Diagnostics Button and LEDs

At blade start-up, POST diagnostics test the CPUs, DIMMs, HDDs, and rear mezzanine modules, and any

failure notifications are sent to Cisco UCS Manager. You can view these notifications in the Cisco UCS

Manager System Error Log or in the output of the show tech-support command. If errors are found, an amber

diagnostic LED also lights up next to the failed component. During run time, the blade BIOS and component

drivers monitor for hardware faults and will light up the amber diagnostic LED as needed.

LED states are saved, and if you remove the blade from the chassis the LED values will persist for up to 10

minutes. Pressing the LED diagnostics button on the motherboard causes the LEDs that currently show a

component fault to light for up to 30 seconds for easier component identification. LED fault values are reset

when the blade is reinserted into the chassis and booted, and the process begins from its start.

The following figure shows the LED diagnostics button on the Cisco UCS B260 Blade Server.

Figure 10: LED Diagnostics Button

must always be securely fastened when the flash memory is in use. Memory that does not fit in the

clip should not be used.

extender is not compatible when any Cisco-certified adapter is installed in slot 1 or slot 2. If a Cisco

VIC 1240 modular LOM card is installed, you will have connectivity through the mLOM but other

adapters will not be recognized.

Cisco UCS B260 M4 and B460 M4 Blade Server Installation and Service Note for Servers with E7 v4 CPUs