Cisco UCS B420 M3 Panduan Peningkatan - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Peningkatan untuk Server Cisco UCS B420 M3. Cisco UCS B420 M3 8 halaman. High performance blade server
Juga untuk Cisco UCS B420 M3: Catatan Instalasi dan Layanan (38 halaman)

Halaman Cetak

Cisco UCS Blade Server

Cisco UCS Manager is now able to complete auto-discovery of the server.

Use Cisco UCS Manager 2.2(2c) to upgrade and activate the server CIMC to version 2.2(2c) or later.

Step 9

Use the GUI or CLI procedures in the

Wait for the server to be discovered and by Cisco UCS Manager.

Step 10

Perform a board controller activation by using the Cisco UCS Manager CLI interface. Use the following

Step 11

sequence of commands:

Note

# scope server <chassis/server>

# scope boardcontroller

# show image

# activate firmware <boardcontroller version>.0 force

# commit-buffer

See also

Do not continue with the next step until the board controller activation completes. Verify whether the

Step 12

activation is complete by using the show version command.

As shown in the example below, wait until the Activate-Status returns Ready. This process takes a few

minutes before Activate-status is successfully completed and returns Ready.

# show version

BoardController:

Running-Vers: 8.0

Package-Vers:

Activate-Status: Ready

Step 13

Clear the WILL_BOOT_FAULT

In the Navigation pane, click the Equipment tab.

On the Equipment tab, expand Equipment > Chassis > Chassis number > Servers, then choose

your server.

In the Work pane, click the General tab.

In the Actions area, click Recover Server.

In the Recover Server dialog, click Reset CIMC (Server Controller), then click OK.

Wait for CIMC to reboot and for Cisco UCS Manager to do a shallow discovery of the server. This

takes two to three minutes. At the end of this process the WILL_BOOT_FAULT is cleared.

Cisco UCS B420 M3 Server Upgrade Guide for Intel E5-4600 v2 Series CPUs

The server automatically reboots after the

The

command in the sequence below lists the board controller versions available for

show image

the server. Always activate the latest board controller image version when you use the

command.

activate firmware

Sample Board Controller Activation Command Sequence, page

UCS Manager Install and Upgrade Guides.

commit-buffer

using the Cisco UCS Manager GUI to reset the server CIMC:

command is executed.

OL-28629-01