Cisco 3800 Series Mengkonfigurasi - Halaman 2

Jelajahi secara online atau unduh pdf Mengkonfigurasi untuk Gerbang Cisco 3800 Series. Cisco 3800 Series 32 halaman. Password recovery procedure
Juga untuk Cisco 3800 Series: Lembar data (8 halaman), Catatan Aplikasi (41 halaman), Panduan Pemecahan Masalah (15 halaman), Lembar data (20 halaman), Panduan Memulai Cepat (40 halaman), Panduan Pengguna (7 halaman)

Halaman Cetak

Information About Configuring Radio Settings on an Access Point

Information About Configuring Radio Settings on an Access

Point

Before you configure radio settings on an access point, you should understand the following concepts:

•

Wireless Device Roles in a Radio Network

Table 6

Universal client mode is not supported on the 85x ISRs.

Note

Table 6

Role in Radio Network

Root access point

Root bridge with or

without clients

Nonroot bridge without

clients

Universal client mode

Support of Workgroup

bridge clients

Data Rate Settings

You use the data rate settings to choose the data rates the AP uses for data transmission. The rates are

expressed in megabits per second. The AP always attempts to transmit at the highest data rate set to

Basic, also called Require on the browser-based interface. If there are obstacles or interference, the AP

steps down to the highest rate that allows data transmission. You can set each data rate (1, 2, 5.5, and 11

megabits per second) to one of three states:

•

At least one data rate must be set to basic.

Note

Wireless Device Roles in a Radio Network, page 2

Universal Client Mode, page 3

shows the role in the radio network for each of the following devices.

Device Role in Radio Network Configuration

Cisco 800

Series ISRs

–

Basic (this is the default state for all data rates)—Allows transmission at this rate for all packets,

both unicast and multicast. At least one of the access point's data rates must be set to Basic.

Enabled—The AP transmits only unicast packets at this rate; multicast packets are sent at one of the

data rates set to Basic.

Disabled—The AP does not transmit data at this rate.

Configuring Radio Settings on an Access Point

Cisco 1800

Cisco 1841

Series ISRs

–

Cisco 2800

Cisco 3800

Series ISRs