Cisco ASR 5000 Panduan Instalasi - Halaman 29

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Gerbang Cisco ASR 5000. Cisco ASR 5000 33 halaman. Applying power and verifying the installation
Juga untuk Cisco ASR 5000: Panduan Instalasi (18 halaman), Prosedur Instalasi (8 halaman), Panduan Instalasi (37 halaman)

Halaman Cetak

Troubleshooting

Step 2

Choose the protocol that you wish to monitor by entering the associated number at the Select: prompt. A right arrow (

> ) appears next to the protocol you selected.

Step 3

Repeat step 2 as needed to choose multiple protocols.

Step 4

Press B to begin the protocol monitor.

WARNING!!! You have selected options that can DISRUPT USER SERVICE

Existing CALLS MAY BE DROPPED and/or new CALLS MAY FAIL!!!

(Under heavy call load, some debugging output may not be displayed)

Proceed? - Select (Y)es or (N)o

Step 5

Enter Y to proceed with the monitor or N to go back to the previous menu.

C - Control Events

D - Data Events

E - EventID Info

H - Disply ethernet

I - Inbound Events

O - Outbound Event

S - Sender Info

T - Timestamps

X - PDU Hexdump

A - PDU Hex/Ascii

+/- Verbosity Level

L - Limit Context

M - Match Newcalls

R - RADIUS Dict

G - GTPP Dict

Y - Multi-Call Trace ((OFF))

(Q)uit,

Step 6

Configure the amount of information that is displayed by the monitor. To enable or disable options, enter the letter

associated with that option (C, D, E, etc.). To increase or decrease the verbosity, use the plus ( + ) or minus ( - ) keys.

The current state, ON (enabled) or OFF (disabled), is shown to the right of each option.

Step 7

Press the Enter key to refresh the screen and begin monitoring.

The monitor remains active until disabled. To quit the protocol monitor and return to the prompt, press q.

Using the Protocol Monitor for a Specific Subscriber

The protocol monitor can be used to display information for a specific subscriber session that is currently

being processed. Depending on the number of protocols monitored, and the number of sessions in progress,

a significant amount of data is generated. It is highly recommended that logging be enabled on your terminal

client in order to capture all of the information that is generated.

Follow the instructions in this section to invoke and configure the protocol monitoring tool for a specific

subscriber session.

Step 1

To invoke the session-specific protocol monitor from the Exec mode enter the monitor subscriber command.

host_name

[local]

peer-fa | peer-lac | sgsn-address | type | username }

(ON )

(OFF)

(ON )

(OFF)

(

(OFF)

(ON )

(no-override)

<ESC> Prev Menu,

<SPACE> Pause,

monitor subscriber { callid | imei | imsi | ipaddr | ipv6addr | msid | msisdn | next-call | pcf |

<ENTER> Re-Display Options

ASR 5000 System Administration Guide, StarOS Release 21.2

Using the Protocol Monitor