Cisco ASR 5000 Panduan Instalasi - Halaman 21
Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Gerbang Cisco ASR 5000. Cisco ASR 5000 37 halaman. Applying power and verifying the installation
Juga untuk Cisco ASR 5000: Panduan Instalasi (18 halaman), Panduan Instalasi (33 halaman), Prosedur Instalasi (8 halaman)
Halaman Cetak
Applying Power and Verifying the Installation
Ethernet Line Card Active LED States
The Active LEDs on the Ethernet Line Cards indicate that the operating software is loaded on the card and
that the card is ready for operation.
The line cards installed remain in ready mode until their corresponding packet processing card is activated
during configuration. While in ready mode, the Active LED is off. When the packet processing card is activated,
the line card installed in the upper-rear chassis slot behind the packet processing card is also activated. The
line card installed in the lower-rear chassis slot behind the packet processing card enters standby mode.
If the LED is not green, use the troubleshooting information in the table to diagnose the problem.
Table 17: Ethernet Line Card Active LED States 8
Color
Green
None
Ethernet Line Card Standby LED States
The Standby LEDs on the Ethernet Line Cards indicate that software is loaded on the cards and that they are
serving as redundant components.
The line cards remain in ready mode until their corresponding packet processing card is activated during
configuration. While in ready mode, the Active LED is off. After the packet processing card activated, the
line card installed in the upper-rear chassis slot behind the packet processing card is also activated. The line
card installed in the lower-rear chassis slot behind the packet processing card enters standby mode.
If the LED is not green, use the troubleshooting information in the table to diagnose the problem.
Description
Troubleshooting
Card is active
None needed for line cards installed in slots 17 through 23 and
26 through 32 after configuration.
If green for line cards in slots 33 through 39 and 42 through 48,
verify that the corresponding line card installed in the upper-rear
chassis slot is installed properly according to the instructions in
this document.
For example, if this LED is green for a line card in slot 33, verify
that the line card in slot 17 is installed properly.
Card is in Ready Mode
This is normal prior to configuration. Neither the Active or the
Standby LED on the card will be on.
OR
Card is not receiving
Verify that the Run/Fail LED is green. If so, the card is receiving
power
power and POST test results are positive. If it is off, refer to
Ethernet Line Card Run/Fail LED States, on page 20
OR
troubleshooting information.
Card is in Standby Mode
Check the state of the Standby LED. If it is green, the card is in
standby mode. Refer to the System Administration Guide for
information on making the card active.
Checking the LEDs on the Ethernet Line Cards
ASR 5000 Installation Guide
for
21