Epson Perfection 1270 Panduan Servis - Halaman 32

Jelajahi secara online atau unduh pdf Panduan Servis untuk Pemindai Epson Perfection 1270. Epson Perfection 1270 46 halaman. Color image scanner
Juga untuk Epson Perfection 1270: Penggantian Kartrid (2 halaman), Mulai di sini (2 halaman), Panduan Petunjuk Instalasi (8 halaman)

Halaman Cetak

EPSON Perfection 1670 Photo/Perfection 1270

4.1 Overview

This chapter explains the maintenance work necessary to keep this product in the best

condition and to prevent problems.

4.1.1 Cleaning

If the product is noticeably dirty, clean it being careful of the following points.

Especially when the Document Glass surface is dirty, fully clean it to remove all dirt

since the read image quality is directly affected.

C A U T I O N

Never use organic solvents, such as thinner and benzene, because they

may deteriorate or degrade the plastic and rubber parts.

Exterior

After wetting a clean cloth with water and then completely squeezing water out of

it, wipe the exterior with that close. If the exterior is extremely dirty, wipe it with a

cloth moistened with a small amount of detergent.

Document Glass

Clean it with a clean, dry cloth. When the Document Glass is especially dirty or

has foreign matter on its surface, wipe it with a cloth moistened with a small

amount of pure water. If the Document Glass has traces of wiping after cleaning,

completely wipe it with a dry, clean cloth again.

Scanner inside

When the Upper Housing has been removed, much dirt and dust enter from the

outside. Therefore, reinstall the Upper Housing after fully air-blowing the scanner

inside and Upper Housing.

MAINTENANCE

4.1.2 Lubrication

Lubrication is required when any part of the Carriage Unit of the scanner has been

replaced or the Carriage moves with noticeably large operation noise. The specified

grease is indicated in Table 4-1, and the lubrication points are shown in Figure 4-1.

Type

Grease

Carriage Shaft

Figure 4-1. Lubrication Points

Note that a failure to strictly observe the specified amount of

C A U T I O N

application will contaminate the mechanisms or lead to a malfunction.

Overview

Table 4-1. Specified Grease

Name

Part Number

Supplier

G-26

1080614

Revision B

EPSON

<Lubrication

point>

Carriage

Shaft

G-26

<Amount of

application>

1.0x3mm