Epson Perfection 3200 Photo Mulai Manual - Halaman 5

Jelajahi secara online atau unduh pdf Mulai Manual untuk Pemindai Epson Perfection 3200 Photo. Epson Perfection 3200 Photo 8 halaman. Product support bulletin(s)
Juga untuk Epson Perfection 3200 Photo: Brosur & Spesifikasi (4 halaman), Buletin Dukungan Produk (23 halaman), Manual (11 halaman), Baca Ini Terlebih Dahulu (2 halaman), Memperbarui (1 halaman), Buletin Dukungan Produk (17 halaman), Setup Manual (2 halaman)

Connect the Scanner

After your software is installed, it's time to get connected.

Remove the sticker from the transportation lock. Use a coin to turn

the lock clockwise one-quarter turn to unlock the scanner carriage.

Remove the sticker from the back of the scanner.

Remove sticker

Connect the cable for the built-in transparency unit to the round

connector on the back of the scanner. You may need to raise the

scanner cover and twist the cable to insert it.

Connect either the USB interface cable that comes with your scanner

or an optional IEEE 1394 (FireWire) cable. Don't connect both.

If you're using USB...

Plug the

USB port. Then plug the

on your computer or USB hub.

Note: Your scanner may not work correctly if you use a USB

cable other than the one supplied by EPSON or if you

connect your scanner to a multi-level USB hub system.

If you're using IEEE 1394 (FireWire)...

Plug one end of the IEEE 1394 cable (not included) into the scanner's

IEEE 1394 port. Then plug the other end into the IEEE 1394 (FireWire,

iLink) port on your computer.

Plug the scanner's power cord into a grounded electrical outlet.

Press the

The scanner lamp comes on.

square end of the USB cable into the scanner's

power button on the front of the scanner to turn it on.

Make sure the

arrow faces up

flat end into any available USB port