Cisco Firepower 1600 Panduan Pemasangan Perangkat Keras - Halaman 37

Jelajahi secara online atau unduh pdf Panduan Pemasangan Perangkat Keras untuk Gerbang Cisco Firepower 1600. Cisco Firepower 1600 44 halaman.

Halaman Cetak
Cisco Firepower 1600 Panduan Pemasangan Perangkat Keras
Mount and Connect
Before you begin
Take note of the following warnings.
Warning
Statement 1009—Laser Radiation
Laser radiation is present when the system is open.
Warning
Statement 1014—Laser Radiation
Laser radiation is present when the system is open and interlocks bypassed.
Warning
Statement 1051—Laser Radiation
Invisible laser radiation may be emitted from disconnected fibers or connectors. Do not stare into beams or
view directly with optical instruments.
Warning
Statement 1053—Class 1M Laser Radiation
Class 1M laser radiation when open. Do not view directly with optical instruments.
Step 1
(Optional) VGA port and USB port—Connect a monitor to the VGA port and a keyboard to the USB port to complete
initial setup at the CLI. You can alternatively complete initial setup using HTTPS on eth0 (see Step 2).
Note
The serial console port is not enabled for initial setup.
Figure 33: Cable Connections
1
eth2 management interface
10 Gigabit Ethernet SFP+ support
Use only Cisco supported SFP+s
transceivers.
Cisco Firepower Management Center 1600, 2600, and 4600 Hardware Installation Guide
Connect Cables, Turn on Power, and Verify Connectivity
2
eth3 management interface
10 Gigabit Ethernet SFP+ support
Use only Cisco supported SFP+s
transceivers.
33