Cisco Linksys WAG200G Panduan Pengguna - Halaman 32
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Gerbang Cisco Linksys WAG200G. Cisco Linksys WAG200G 39 halaman. Linksys wireless-g adsl home gateway
Halaman Cetak
AppendixD
Appendx D:
Regulatory Informaton
FCC Statement
This product has been tested and complies with the
specifications for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in
a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not
installed and used according to the instructions, may
cause harmful interference to radio communications.
However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception,
which is found by turning the equipment off and on, the
user is encouraged to try to correct the interference by
one or more of the following measures:
Reorient or relocate the receiving antenna
•
Increase the separation between the equipment or
•
devices
Connect the equipment to an outlet other than the
•
receiver's
Consult a dealer or an experienced radio/TV technician
•
for assistance
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure
limits set forth for an uncontrolled environment. This
equipment should be installed and operated with
minimum distance 20 cm between the radiator and your
body.
Safety Notices
Caution: To reduce the risk of fire, use only No.26 AWG
•
or larger telecommunication line cord.
Do not use this product near water, for example, in a
•
wet basement or near a swimming pool.
Avoid using this product during an electrical storm.
•
There may be a remote risk of electric shock from
lightning.
Wreless-G ADSL Home Gateway
Regulatory Information
Industry Canada Statement
This device complies with Industry Canada ICES-003 and
RSS210 rules.
Operation is subject to the following two conditions:
1.
This device may not cause interference and
2.
This device must accept any interference, including
interference that may cause undesired operation
of the device.
To reduce potential radio interference to other users,
the antenna type and its gain should be so chosen
that the EIRP is not more than required for successful
communication.
Industry Canada Radiation Exposure Statement
This equipment complies with IC radiation exposure limits
set forth for an uncontrolled environment. This equipment
should be installed and operated with minimum distance
20 cm between the radiator & your body.
This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
Avis d'Industrie Canada
Cet appareil est conforme aux normes NMB003 et RSS210
d'Industrie Canada.
L'utilisation de ce dispositif est autorisée seulement aux
conditions suivantes :
1.
il ne doit pas produire de brouillage et
2.
il doit accepter tout brouillage radioélectrique reçu,
même si ce brouillage est susceptible de compromettre le
fonctionnement du dispositif.
Afin de réduire le risque d'interférence aux autres
utilisateurs, le type d'antenne et son gain doivent
être choisis de façon à ce que la puissance isotrope
rayonnée équivalente (p.i.r.e.) ne soit pas supérieure
au niveau requis pour obtenir une communication
satisfaisante.
Avis d'Industrie Canada concernant l'exposition
aux radiofréquences
Ce matériel est conforme aux limites établies par IC
en matière d'exposition aux radiofréquences dans un
environnement non contrôlé. Ce matériel doit être installé
et utilisé à une distance d'au moins 20 cm entre l'antenne
et le corps de l'utilisateur.
L'émetteur ne doit pas être placé près d'une autre antenne
ou d'un autre émetteur, ou fonctionner avec une autre
antenne ou un autre émetteur.
31