Cisco Linksys WAG325N Panduan Pengguna - Halaman 15

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Gerbang Cisco Linksys WAG325N. Cisco Linksys WAG325N 50 halaman. 2.4ghz wireless-n adsl2+

Halaman Cetak

Wireless-N ADSL2+ Gateway

Wireless Connection to a Computer

If you want to use a wireless connection to access the Gateway, follow these instructions:

1. Make sure that all of your network's hardware is powered off, including the Gateway and all computers.

2. Connect a phone cable from the DSL port on the Gateway's back panel to the wall jack of the ADSL line. A

small device called a microfilter (not included) may be necessary between each phone and wall jack to

prevent interference. Contact your ISP if you have any questions.

NOTE: A small device called a microfilter (not included) may be necessary between each phone

and wall jack to prevent interference. Contact your ISP if you have any questions.

3. Connect the power adapter to the Power port, and then plug the power adapter into a power outlet.

NOTE: You should always plug the Gateway's power adapter into a power strip with surge

protection.

The Power LED on the front panel will light up green as soon as the power adapter is connected properly. The

Power LED will flash for a few seconds, and then it will be solidly lit when the self-test is complete. If the LED

flashes for one minute or longer, see "Appendix A: Troubleshooting."

4. Power on one of the computers on your wireless network(s).

5. For initial access to the Gateway through a wireless connection, make sure the computer's wireless adapter

has its SSID set to linksys (the Gateway's default setting), and its wireless security is disabled. After you have

accessed the Gateway, you can change the Gateway and this computer's adapter settings to match your usual

network settings.

Go to "Chapter 5: Configuring the Wireless-N ADSL2+ Gateway."

Chapter 4: Connecting the Wireless-N ADSL2+ Gateway

Wireless Connection to a Computer

Figure 4-4: Connect the ADSL Line

Figure 4-5: Connect the Power

NOTE: You should always change the SSID from

its default, linksys, and enable wireless security.