Epson Perfection V100 Series Panduan Informasi Produk - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Informasi Produk untuk Pemindai Epson Perfection V100 Series. Epson Perfection V100 Series 9 halaman. Product support bulletin(s)
Juga untuk Epson Perfection V100 Series: Spesifikasi (2 halaman), Petunjuk Keselamatan Penting (4 halaman), Mulai Cepat (4 halaman), Buletin Dukungan Produk (23 halaman), Buletin Dukungan Produk (40 halaman), Buletin Dukungan Produk (24 halaman), Buletin Dukungan Produk (29 halaman), Buletin Dukungan Produk (8 halaman), Buletin Dukungan Produk (3 halaman), Buletin Dukungan Produk (11 halaman), Buletin Dukungan Produk (14 halaman), Buletin Dukungan Produk (12 halaman), Buletin Dukungan Produk (40 halaman), Buletin Dukungan Produk (11 halaman), Buletin Dukungan Produk (40 halaman), Buletin Dukungan Produk (22 halaman), Buletin Dukungan Produk (12 halaman), Buletin Dukungan Produk (21 halaman), Buletin Dukungan Produk (12 halaman), Mulai di sini (2 halaman), Mulai di sini (2 halaman), Mulai di sini (2 halaman), Mulai di sini (4 halaman)

Epson Perfection V100 Photo

3. Lay the cover down flat next to the scanner.

Note:

When scanning without the scanner cover, gently press down on

your document to flatten it.

4. When you are finished scanning, replace the scanner cover.

To scan film strips or slides, you need to remove the document

mat from the scanner cover. This uncovers the transparency

unit window so your scanner can use it to scan your film or

slides.

1. Open the scanner cover and gently slide up the document

mat to remove it.

2. Use a non-abrasive microfiber cloth to wipe the document

table before placing your film or slides.

To place film for scanning, see the next section.

To place slides for scanning, see page 5.

4 - Epson Perfection V100 Photo

Placing Film in the Holder

1. Open the cover of the 35 mm film strip holder.

2. Slide your film strip all the way into the film holder with the

shiny base side facing down. Your images and any wording

on the film strip should appear backwards on the side that

faces up.

Note:

Hold the edge of the film gently or use gloves to touch the film;

otherwise you may damage the film.

Make sure the white stickers on the back of the film holder and

the areas around them are not scratched, dusty, or covered in

any way. If the areas are obscured, the scanner may have trouble

recognizing your film in Full Auto Mode.

Do not cover the small holes in the film holder.

3. Close the cover and press it down until you hear a click.

7/06