Cisco S395 Panduan Memulai - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Memulai untuk Gerbang Cisco S395. Cisco S395 18 halaman. Web security appliance
Juga untuk Cisco S395: Manual (24 halaman), Panduan Pemasangan Perangkat Keras (50 halaman)

Halaman Cetak

Temporarily Change Your IP Address for Remote Access

To remotely configure the appliance using the network connection, you must temporarily change the

IP address of your computer.

Make a note of your current IP configuration settings as you will need to revert to these settings after

Note

you finish the configuration.

Alternatively, you can use the serial console to configure the appliance, without changing the IP address.

If you use the serial console, see

Temporarily Change Your IP Address on Windows

Note

The exact steps depend on the version of your operating system.

Procedure

Connect your laptop to the primary Management Port (labeled M1) using the cross over or Ethernet cable

Step 1

included in the system box. The Cisco Web Security Appliance uses the M1 Management port only. See

"Plan the Installation" section on page

Go to the Start menu and choose Control Panel.

Step 2

Double-click Network and Sharing Center.

Step 3

Cisco Web Security Appliance S195, S395, S695, and S695F Getting Started Guide

Connect to the Appliance, page