Cisco VG400 series Panduan Konfigurasi Perangkat Lunak - Halaman 19
Jelajahi secara online atau unduh pdf Panduan Konfigurasi Perangkat Lunak untuk Gerbang Cisco VG400 series. Cisco VG400 series 22 halaman. Voice gateway
Juga untuk Cisco VG400 series: Panduan Pemasangan Perangkat Keras (40 halaman), Menginstal (13 halaman)
Halaman Cetak
Configuring Voice Ports
This chapter explains how to configure voice ports using the commands specific for Cisco VG400 Analog
Voice Gateways and associated service modules.
This chapter contains the following topics:
•
•
•
Prerequisite
Before you configure voice ports on Cisco VG400 you must establish a working IP network.
Configuring the Voice Port
This section discuss the changes and modifications on the following commands:
loop-length
The loop-length CLI is created to configure the analog FXS voice port. It has the following format:
voice-port x/y/z
[no] loop-length [long | short]
The loop-length CLI has the following characteristics:
• For the Cisco VG400 platform, the default is short loop-length. This command is not applicable to analog
• This command is applicable to all 48 FXS voice ports on SM-D-48FXS-E and the first 4 (0-3) FXS voice
• The default FXS is short loop-length and long loop-length FXS needs to be configured.
• The first eight voice ports 0/0/0-7 can be configured as long loop (OPX-lite).
• FXS voice ports on VIC 1 (0/1/0 - 0/1/23) will not support long loop. By default, they are short-loop
Prerequisite, on page 13
Configuring the Voice Port, on page 13
Cisco IOS Bulk Configuration, on page 14
FXS on motherboard slot.
ports on SM-D-72FX like the Cisco VG400 platform.
FXS.
C H A P T E R
Cisco VG400 Voice Gateway Software Configuration Guide
3
13