DIGMESA FC Panduan Pengguna - Halaman 10

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Pengontrol DIGMESA FC. DIGMESA FC 12 halaman. Flow controller

Halaman Cetak

Programming pulse count/litre and limit

The limit value (in litres) and pulse count/litre (calibration factor) can be pro-

grammed only with an FC programmer which is available as an option, Item

No.925-0200. Proceed as follows in order to change these values:

Undo the fixing screw

measuring device is connected for the FC and pull the MSD carefully off. The FC

remains electrically live.

Connect the MSD of the FC programmer to the FC

the MSD points to the right. The (already set) pulse count per litre is now shown

on the display: 4 digits, with the digit at the far right blinking. This pulse count

must correspond to that of the connected measuring device. You can find this

information on the relevant data sheet or on the Internet at www.digmesa.com.

If the pulse value is incorrect, it can be changed as follows.

Change the value of the blinking digit by pressing key

reaches 9, it changes to 0 by pressing key

In order to access the next digit, press key

key

When you have reached the last digit at the left, press key

now see a 5-digit number on the display. This number indicates the limit value in

litres.

Program your required value with the aid of keys

Points 3 and 4.

When you have reached the last digit at the left, press key

confirms the entries and the display disappears. The display remains blank until

the MSD of the FC programmer is disconnected. If you wish to repeat program-

ming, press keys

If the MSD of the FC programmer has been disconnected, 0.00 and LITRES are

shown on the FC display. Plug the MSD which you disconnected in Point 1. onto

FC- - - - - slot A

slot A

slot A and tighten it with the fixing screw

again in Working mode and counts the litres on the basis of the newly set pulse

count.

until the required value is shown on the display.

and

(Fig. 1) of the MSD slot A

simultaneously for approx. 1 sec.

Page 10

slot A to which the cable of the

slot A

FC- - - - - slot A

slot A

slot A, so that the bracket of

slot A

. When the digit

again.

. Continue changing the digit with

and

(Fig. 1). The FC is now once

again. You will

as described in

again. This