DIGMESA FC Panduan Pengguna - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Pengontrol DIGMESA FC. DIGMESA FC 12 halaman. Flow controller

Halaman Cetak

2.3

Connection 230 VAC plug FC-slot B

Remove the MSD with 3 contacts by pushing out the plug

screw

Remove the plastic screw

parts in the order in which you removed them over the cable, followed, finally,

by the housing . Expose the 2 wires of the cable (2-core, max 0.75 mm

section) by cutting back the cable sheath over a length of approx. 15 mm. Then

strip the insulation from the individual wires over a length of approx. 5 mm.

Now neatly twist the wires, insert them into the individual terminals and firmly

tighten them. Insert phase (brown in Switzerland) into terminal 1, negative (blue

in Switzerland) into terminal 2. The terminal with the earthing symbol is not

used.

Plug with 3 contacts

Plug the rubber seal

earthing symbol connector to earthing symbol

FC-slot B. Guide the housing

that the cable outlet points to the left. Now firmly

tighten with the fixing screw

Guide the round rubber seal , washer

tic screw

tighten them so that the cable is held firmly and

tightly.

on the rear side of the MSD.

and plug

over the cable into the housing

, washer

and rubber seal

Figure 2

onto FC

FC- - - - - slot B

slot B

slot B,

slot B

over the plug

and plas-

Page 6

. Pull the individual

Housing

Fixing screw

Rubber seal, round

Washer

Plastic screw

Rubber seal, rectangular

Plug with 3 contacts

and

FC-slot B

with the fixing

cross-