DIGWDF ESP/XBee Snap-In Panduan Pengguna - Halaman 5
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Adaptor DIGWDF ESP/XBee Snap-In. DIGWDF ESP/XBee Snap-In 9 halaman. Wireless adapter board
Halaman CetakUsing the Snap-In: SS8, SS16, SS24 on-board mounting
1. Carefully remove the U5 chip from the controller. P
2. position the adapter so that the two rows of 4 pins will fit into the U5 socket and gently
insert the adapter into the U5 socket so the header pins are firmly
seated in the socket.
3. On an SS24 controller, the mounting hole near the top of the adapter
PCB should be above a mounting hole next to the U4 chip on the
controller's PCB. A small yet long screw with 3 nuts can be used to
mount the adapter firmly to the controller; then position the other
two nuts to support the adapter PCB at the right height and the top
nut to finish the mounting. (See photo to right.)
4. The SS8 and SS16 controllers do not have an extra mounting hole but
you can easily drill a 1/8" hole on your own. Verify the position for the
hole that it doesn't hit any traces on the top or bottom of the PCB and
take your time.
Using the Snap-In: SS8, SS16, SS24 off-board mounting
1. Carefully remove the U5 chip from the controller
2. Mount the adapter elsewhere inside the
controller box.
3. Using individual connection wires, connect the
adapter's pins to the U5 socket as shown in the
photo to the right: (strands of solid cat5 wire
work great for connecting wires). Consider that
you may decide to solder connection wires to the
bottom side of the board, using the
corresponding solder pads for the U5 socket.
4. Note: in this connection scenario, you should not
install the 1x4 stackable headers on the adapter.
DIGWDF XBee/ESP Snap-In Assembly & User Guide – v 20170308 -Page 5